General Research of Electronics Inc 0716 用户手册

Basic CCDump data includes the system type, the Object ID of 
the TSYS object (if applicable), and the “raw” control channel 
messages as they are transmitted by the system. This data is 
delimited by “:” symbols. Basic CCDump data is sent to the PC/
IF port under the following conditions:

• In TUNE mode, when the radio is tuned to a trunking control 

channel

• In TSYS analysis mode, when the radio is tuned to an active 

control channel in the TSYS channel list

Expanded CCDump data includes all of the data that is provided 
in the Basic CCDump data display, and provides additional 
human-readable decoding of certain trunked control channel 
messages. Expanded CCDump data is sent to the PC/IF port 
under the following condition:

• When the radio is monitoring a trunked control channel while in

MAN or SCAN modes

The following describes the CCDump message format for the 
supported modes:

<Msg Type>:T<xxxx>:<CC data>[:<Expanded CCDump description>]

<Msg Type>=always 3 ASCII chars:

WXS (WX SAME)

WXT (WX 1050Hz tone)

P25, M36, LTR, EDW, EDN

<xxxx>    = the hexadecimal representation of the TSYS's File

System ID (for WXS and WXT, this is the current Wx 

Chan 0-6, if in TUNE mode, “AAAA”)

<CC data> = the "osw" from the CC. The format necessarily 

depends on the system type:

P25: <X1><X2><X3><X4><X5><X6><X7><X8><X9><XA><XB><XC>

<X1> - <XC> = 12 2-digit hexadecimal bytes 

from the last msg

M36: <cmd> <dir> <id>

<cmd> = 3-digit (10-bit) hex "command" value

<dir> = direction bit

<id>  = 4-digit (16-bit) hex "id" value

LTR: <RR>: <A>-<GG>-<HH>-<III>-<FF>

<RR>  = repeater on which the msg was received

<A>   = area

<GG>  = Goto/In-Use repeater #

<HH>  = Home Repeater #

<III> = Group ID

0716 User Manual

Page 121