General Research of Electronics Inc 0716 用户手册
Trunked Mode
Analysis Display
LTR home repeater
HR:hh A-HH-GGG
where HR=the home repeater number
of the tuned frequency, A-HH-
GGG=the Area, Home Repeater and
Group ID of the LTR talkgroup
of the tuned frequency, A-HH-
GGG=the Area, Home Repeater and
Group ID of the LTR talkgroup
Motorola analog voice channel
VC: lsTGID-nnnnn
where lsTGID shows the decoded
talkgroup ID data from the lowspeed
data stream
talkgroup ID data from the lowspeed
data stream
Please note that the analog lowspeed
data protocol does not provide error
correction, and some false “VC:
lsTGID” readings should be expected.
data protocol does not provide error
correction, and some false “VC:
lsTGID” readings should be expected.
You may wish to use the 0716's Tune LED feature to obtain
a visual indication of signal strength using the tri-color LED. To
activate the Tune LED, press
a visual indication of signal strength using the tri-color LED. To
activate the Tune LED, press
PGM
, then the GLOB softkey. Press
the
key until Tune LED: Off appears in the display.
Use the
keys to toggle Tune LED on or off, then press the
SAVE softkey to save your changes to the radios configuration
memory.
memory.
Using dedicated Limit and Service search modes
The
SRCH
key provides immediate access to the dedicated
search modes of your 0716. Pressing the
SRCH
key cycles
through each search mode in this order: Limit, Railroad, Public
Safety, Aircraft, Ham, CB, Marine, and FRS/GMRS/MURS/DOT.
Safety, Aircraft, Ham, CB, Marine, and FRS/GMRS/MURS/DOT.
LMIT Search Mode
Your scanners dedicated LMIT search mode provides you with
the ability to create a limit search with a search frequency range
between upper and lower limit frequencies that you specify and
perform the limit search directly without creating a new LMIT
object. You can then monitor that frequency range for
transmissions.
the ability to create a limit search with a search frequency range
between upper and lower limit frequencies that you specify and
perform the limit search directly without creating a new LMIT
object. You can then monitor that frequency range for
transmissions.
To enter LMIT mode, press the
SRCH
key on the keypad
repeatedly until the display indicates LMIT search as follows:
0716 User Manual
Page 75