Rockford Corporation PMX-BTUR 用户手册

5

(-)

Fig. 2

Locate the (2) philips head screws on the side of the 

unit nearest to the track up and track down buttons. 

Loosen both screws and gently pull out the battery 

tray. Insert (1) CR2032 into the tray with the domed 

(-) of the battery facing up. You will knotice on the 

underside of the tray there is a (+) molded into the 

tray. Make sure the positive + (flat side) of the battery 

is facing the same direction as the label on the tray. 

Slide the tray back into the unit and tighten the (2) 

phillips head screws:

Using the included velcro mounting adapter, hold 

the rubber side of adapter against the inside of the 

steering wheel.Wrap the velcro strap around the wheel 

then insert it through the groove on the opposite side 

of the adapter. Wrap the straps extra slack around the 

wheel and secure it to the velcro. Finally, slide the unit 

into the adapter.:

To release the remote from the steering wheel mount, 

push the tab on the underside of the unit in the direc-

tion the arrow is pointing. While holding the tab, pull 

the unit straight up and out of the mount. If the unit is 

going to be used standalone and not fixed, included 

is a flat cover that slides on to the unit making it a 

mobile remote. 

When using the remote with the steering/bar mount, 

you will use the soft cover. This will cover the battery 

tray and finish off the back of the remote when not 

using it in the standalone option. Simply press the 

rubber studs into the existing holes on the back of the 

remote to secure it.: