Elstat Electronics Ltd 121-0184 用户手册
Issue 5
P a g e - 5 -
Elstat, Astra Business Centre, Roman Way, Preston, Lancashire, PR2 5AP, United Kingdom Telephone: +44 161 22 77 200 www.elstatgroup.com
Design & Development – Regulatory & Test Department
E ls tat
B luetooth
Modu le Pin
B luetooth
Modu le Pin
Function
1
VDD
2
IRQ
3
CLK
4
MOSI
5
GND
6
MISO
7
CSN
8
RST
Table. 1 Elstat Bluetooth Module connection pins descriptions
1.4
FCC ID certification Number (FCC ID: 2ACHH121-0184)
The intended final product for the Elstat Bluetooth Module shall be labelled with the FCC ID attached. The FCC ID label must be permanently
marked (etched, engraved, indelibly printed etc.) either directly on the final product or on a tag that is permanently affixed (riveted, welded,
etc.) to the final product. The FCC ID label must be readily visible to the purchaser at the time of purchase.
marked (etched, engraved, indelibly printed etc.) either directly on the final product or on a tag that is permanently affixed (riveted, welded,
etc.) to the final product. The FCC ID label must be readily visible to the purchaser at the time of purchase.
1.5
Usability
This module is only intended to be incorporated into products which Elstat design or Elstat have approved for the module to be used on. Any
other use of this module shall be deemed to invalidate the certification of this module. This product must not be collocated with any other
intentional transmitters within 20cm
other use of this module shall be deemed to invalidate the certification of this module. This product must not be collocated with any other
intentional transmitters within 20cm
1.6
FCC Warning statement
The following should be present on all products that are subject to radio approval under Part 15 of the FCC Rules.
FCC warning statement:
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
(2) This device must accept any interference received, including interference that may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must follow the
specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate
the equipment.
the equipment.
1.7
Information to user
Under §15.21 Information to user.
The user’s manual or instruction manual for an intentional or unintentional radiator shall caution the user that changes or modifications not
expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. In cases where the
manual is provided only in a form other than paper, such as on a computer disk or over the Internet, the information required by this section
expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. In cases where the
manual is provided only in a form other than paper, such as on a computer disk or over the Internet, the information required by this section