Dabir Surfaces Inc. 110024 用户手册

• 

Please read entire manual carefully and completely before using.

• 

As with any device, failure to carefully read and follow all instructions and safety information

 

prior to use may result in decreased product performance or failure.

•  It is the responsibility of the caregiver to ensure that        

    the user can operate this product safely.

•  Power “OFF” or “STOP” Pneumatic Controller for cardiac arrest  

    events.  The unit is not intended for use during CPR.  (See Section 6)

•  Properly route and secure Power Cord and hoses to avoid 

    trip hazard.

 

•  Maintain accessibility to Power Cord such that it can   

 

    be easily unplugged.

•  The Dabir System must be cleaned using the outlined  

       

    guidelines within this manual. Cleaning conditions that do not reflect  

    the recommended cleaning process may result in irreparable  

    damage. 

•  Disconnect the Pneumatic Controller from the wall power source  

    prior to cleaning and inspecting.

•  Do not immerse or allow liquid to enter any part 

    of the Pneumatic Controller.

•  Keep DabirAIR Micropressure Overlay vent free and clear of liquids,  

    contamination and debris to avoid over inflation. 

•  Do not operate the Pneumatic Controller in the presence 

    of flammable liquids or gases.

•  Only use the DabirAIR Pneumatic Controller with manufacturer  

    approved Overlays and Accessories to ensure proper system  

    function.

•  The DabirAIR Micropressure and DabirAIR Microclimate 

    products are OVERLAYS, and are not intended to be used  

    without an underlying support mattress or pad.

•  Do not block air intake ports on the bottom of the Pneumatic  

    Controller or the exhaust vent under the handle.

•  Do not place Pneumatic Controller on top of loose articles which may  

    block air intake ports.

•  System must be at room temperature prior to operation.  Allow  

    Pneumatic Controller and Overlay to acclimate to room temperature  

    for one hour prior to operation.

3

  

WARNING: No modification of this 

equipment is allowed.

DOC# R01-0006-00004-AA  

•  Do not place the Pneumatic Controller in direct sunlight.

•  The Pneumatic Controller must be stored and operated within 

    designed operating conditions specified in this manual.     

    Operating the Pneumatic Controller outside these 

    ranges may cause damage to the device which could 

    result in premature failure.  

•  The Pneumatic Controller must be used with specified operating 

    wall currents.  All other alternative power sources 

    and currents may result in irreparable damage to 

    the system and possible hazardous event to the 

    patient or caregiver.

•  Equipment may be hazardous if misused.  

    

•  Modification of the device voids warranty and 

    may compromise intended function.  Service should

    be performed exclusively by the manufacturer or 

    manufacturer’s representative.

•  If Pneumatic Controller is damaged during the shipping process, 

    please contact the manufacturer for appropriate action.

•  If Pneumatic Controller is dropped during use with noticeable

    damage, please remove from service and contact the manufacturer  

    for appropriate action.  

•  Do not transport or carry the Pneumatic Controller with an

     Overlay attached.

•  This device requires the use of a shielded Power Cord

     for compliance with emissions limits.  Do not operate

    device without manufacturer supplied Power Cord.

•  Do not use in an MRI environment.

•  Turn Dabir System “OFF” during patient transfer and 

    before patient positioning.  

•  It is the responsibility of the caregiver to adequately secure and  

    protect the patient against patient falls.