Yuneec Technology Co. Limited SR12E 用户手册
SR12E User Manual
Connecting SR12E to ST24
Plug the cable from FC0(flight control for HX4) into SR12E socket, and power on HX4. Lean HX4
nose forward twice times, the BLUE LED of SR12E will flash slowly, indicating the receiver ready
for binding. When the binding between SR12E and ST24 completes (see the following instructions
of Binding HX4 and ST24), the BLUE LED will be off. Turn on ST24, press FPV and press ‘Take
off’.
Binding HX4 and ST24
z HX4 with gimbal, camera and LK58
Push the POWER Switch to the left side and Power on ST24→Keep HX4 nose to north, and
power on HX4 as the arrow shows →Wait until HX4 completes self-inspection, and BLUE LED
flashes→ Hold HX4 tail and lean the copter forward twice, and YELLOW LED flashes →Press
‘PAD’ →Press ‘Settings’ and find WiFi signal of LK58, choose it and enter the password, press
nose forward twice times, the BLUE LED of SR12E will flash slowly, indicating the receiver ready
for binding. When the binding between SR12E and ST24 completes (see the following instructions
of Binding HX4 and ST24), the BLUE LED will be off. Turn on ST24, press FPV and press ‘Take
off’.
Binding HX4 and ST24
z HX4 with gimbal, camera and LK58
Push the POWER Switch to the left side and Power on ST24→Keep HX4 nose to north, and
power on HX4 as the arrow shows →Wait until HX4 completes self-inspection, and BLUE LED
flashes→ Hold HX4 tail and lean the copter forward twice, and YELLOW LED flashes →Press
‘PAD’ →Press ‘Settings’ and find WiFi signal of LK58, choose it and enter the password, press
‘Connect’, it will show “Connected”→Press
twice and back to the main interface →Press
‘FPV’ on the main screen of ST24 →Press ‘System Settings’ →Press ‘Refresh’ →Choose your
Model and Camera →Press ‘Bind’ →Press
→Press ‘Take Off’ and you will hear 2 beeps,
z Lack anyone of gimbal, camera or LK58
Push the POWER Switch to the left side and Power on ST24→Keep HX4 nose to north, and
power on HX4 as the arrow shows →Wait until HX4 completes self-inspection, and BLUE LED
Push the POWER Switch to the left side and Power on ST24→Keep HX4 nose to north, and
power on HX4 as the arrow shows →Wait until HX4 completes self-inspection, and BLUE LED