Ulterius Technologies LLC FDN40 用户手册
CHAPTER 1: INTRODUCTION
Configuration User Manual
24
© Ulterius Technologies, LLC 2016. Confidential & Proprietary.
1.5 General Configurations
1.5.1
CLI Modes
The following table provides the access and exit methods to various general
configuration modes.
configuration modes.
Table 1-3: General Configurations
Command Mode
Access Method
Prompt
Exit method
User EXEC
This is the initial mode to
start a session.
start a session.
UltOs>
The logout method is
used.
used.
Privileged EXEC
The User EXEC mode
command enable, is used to
enter the Privileged EXEC
mode.
command enable, is used to
enter the Privileged EXEC
mode.
UltOs#
To return from the
Privileged EXEC mode to
User EXEC mode the
disable command is
used.
Privileged EXEC mode to
User EXEC mode the
disable command is
used.
Global Configuration
The Privileged EXEC mode
command configure
terminal, is used to enter
the Global Configuration
mode
command configure
terminal, is used to enter
the Global Configuration
mode
UltOs(config)#
To exit to the Global
Configuration mode the
exit command is used and
to exit to the Privileged
EXEC mode the end
command is used.
Configuration mode the
exit command is used and
to exit to the Privileged
EXEC mode the end
command is used.
Interface
Configuration
Configuration
The Global Configuration
mode command interface
<interface-
type><interface-id> is used
to enter the Interface
Configuration mode.
mode command interface
<interface-
type><interface-id> is used
to enter the Interface
Configuration mode.
UltOs(config-if)#
To exit to the Global
Configuration mode the
exit command is used and
to exit to the Privileged
EXEC mode the end
command is used.
Configuration mode the
exit command is used and
to exit to the Privileged
EXEC mode the end
command is used.
VLAN Configuration
The Global Configuration
Mode command VLAN
<VLANid>, is used to enter
the VLAN configuration
mode
Mode command VLAN
<VLANid>, is used to enter
the VLAN configuration
mode
UltOs(config-vlan)# To exit to the Global
Configuration Mode, the
exit command is used and
to exit to the Privileged
EXEC mode, the end
command is used
exit command is used and
to exit to the Privileged
EXEC mode, the end
command is used
NTP Configuration
The Global Configuration
mode command ntp is used
to enter the NTP
configuration mode.
mode command ntp is used
to enter the NTP
configuration mode.
UltOs(config-ntp)#
To exit to the Global
Configuration mode the
exit command is used and
to exit to the Privileged
EXEC mode the end
command is used.
Configuration mode the
exit command is used and
to exit to the Privileged
EXEC mode the end
command is used.
1.5.2
SNMP Configurations
SNMP configurations can be done in two ways:
1. Using NETSNMP commands
2. Using Scotty manager
1. Using NETSNMP commands
2. Using Scotty manager
We have done the configurations using Scotty manager version 2.1.10. To
start the configurations, follow the steps given below.
start the configurations, follow the steps given below.