Fujitsu 600GB 2.5" 10K SAS FTS:ETED6HB-L 用户手册
产品代码
FTS:ETED6HB-L
Chapter 1 Components
1.2 Drive Enclosures
1.2 Drive Enclosures
ETERNUS DX60 S2 Disk storage system User’s Guide -Operation-
25
Copyright 2011 FUJITSU LIMITED
P3AM-5512-02ENZ0
●
Part explanation
•
LEDs
The states of LEDs are listed below.
The states of LEDs are listed below.
Table 1.9
Status and meanings of each LED (3.5" disks)
1.2.4
Components (Rear)
This section describes the expanders and the power supply units in the rear of the drive enclo-
sure.
sure.
■
Expander
The expander is a component that controls how the controller and the disks interact.
Figure 1.23 Expander
●
Part explanation
•
DI (IN) port
These ports are connectors for miniSAS cables.
These ports are connectors for miniSAS cables.
LED name
LED status
Disk status
DISK READY/
FAULT
FAULT
(green)
The disk is operating normally.
(blinks green)
(orange)
The disk is in error status.
(blinks orange)
In response to commands from Microsoft Virtual Disk
Service (VDS), the location of the disk is identified.
Service (VDS), the location of the disk is identified.
UNIT READY/FAULT LED
DI (IN) LINKUP LED
DI (IN) port
These ports are not used.
IDENTIFY LED