Fujitsu 600GB 2.5" 10K SAS FTS:ETED6HB-L 用户手册
产品代码
FTS:ETED6HB-L
Chapter 5 Installing Optional Products
5.2 Installing Drive Enclosures
5.2 Installing Drive Enclosures
ETERNUS DX60 S2 Disk storage system User’s Guide -Operation-
68
Copyright 2011 FUJITSU LIMITED
P3AM-5512-02ENZ0
The M5 screw positions for the rack rails are determined relative to the drive enclosure
base line.
The M5 screws should be inserted in the 1st and 3rd holes above the base line.
base line.
The M5 screws should be inserted in the 1st and 3rd holes above the base line.
(3)
Tighten the M4 screws of the rack rails that were slightly unscrewed in
3
Remove the front cover.
For details on how to attach the front cover, refer to
.
4
Install the drive enclosure in the rack.
5
Fix the drive enclosure in the rack.
Use the two thumb screws at the front of the drive enclosure to fasten it in the rack.
CAUTION
Do
•
When installing or removing the drive enclosure to or from the
rack, make sure to have the right and left sides and the bottom
of the drive enclosure by two or more people. Failure to do so
may cause injury.
rack, make sure to have the right and left sides and the bottom
of the drive enclosure by two or more people. Failure to do so
may cause injury.
Drive enclosure
1st position
(M5 screws)
3rd position
(M5 screws)
1st position
(M5 screws)
3rd position
(M5 screws)
2U
Rack rails
Base line of
drive enclosure
[Left]
[Right]
(Rear rack pillars)
Thumb screw