QUICCO SOUND Corporation M1REV3 用户手册

Thank you for purchasing the Wireless MIDI Interface mi.1.

mi.1 is an interface inserted into electronic musical instruments with 

MIDI connectors that allows bidirectional MIDI communication 

between iPhone/iPad/Mac and the instrument.



 Insert only into MIDI connectors.



 Use only as an interface for electronic musical instruments.



 mi.1: 1



 Operation Manual (this manual): 1



 Wireless system 

Bluetooth Low Energy 



 Connector plug 

MIDI plug (5-pin DIN) x 2



 Power consumption  7 mW (when MIDI OUT is 3.3 V)

 

25 mW (when MIDI OUT is 5 V)



 Hall element switch x 1



 Magnet x 1



 LED (white) x 1

*The specifications and external appearance may change without 

notice due to continuous improvements.

Be sure to read this manual before use. 

After reading this manual, store it in a safe 

place.

Intended Use

Included Items

Specifications

Do not leave this product in the following places:



 Places where there is direct sunlight, or inside automobiles in the sun. 

Places with high heat such as near heaters.



 Places with high humidity or where condensation occurs.

This product does not have a waterproof construction. Use and store in 

places where it will not be exposed to water or other liquids.



 Insert only into MIDI connectors.



 Follow local regulations and ordinances when disposing of this 

product.

Usage Precautions

Wireless Precautions

Check that the power of the electronic musical instrument 

has been turned off.

Insert mi.1 into the MIDI IN/OUT ports as shown.

Update of the firmware is recommended so that mi.1 can be used 

in the most optimal condition. To do this, please download the 

dedicated iPhone/iPad application "Piano Jukebox" (free) from 

App Store.

Installation

How to connect to iPhone/iPad/Mac

First Step

Firmware Version

The arrows on the product show 

the direction of the MIDI signal. 

Use them as guides for installation.

iPhone/iPad are registered trademarks of Apple Inc.

MIDI is a registered trademark of the MIDI Manufacturers 

Association (MMA).

Bluetooth is the registered trademark of Bluetooth SIG.Inc.

©2014 QUICCO SOUND Corporation.

This symbol on the products, packaging, and/or accompanying 

documents means that used electrical and electronic products 

should not be mixed with general household waste.

For proper treatment, recovery and recycling of old products, please take 

them to applicable collection points, in accordance with your national 

legislation and the Directives 2002/96/EC.

By disposing of these products correctly, you will help to save valuable 

resources and prevent any potential negative effects on human health 

and the environment which could otherwise arise from inappropriate 

waste handling.

For more information about collection and recycling of old products, 

please contact your local municipality, your waste disposal service or the 

point of sale where you purchased the items.

[For business users in the European Union]

If you wish to discard electrical and electronic equipment, please contact 

your dealer or supplier for further information.

[Information on Disposal in other Countries outside the European Union]

This symbol is only valid in the European Union. If you wish to discard 

these items, please contact your local authorities or dealer and ask for the 

correct method of disposal.

For European Union

NOTE: This equipment has been tested and found to comply with the 

limits for a Class B digital device, pursuant to part 15 of the FCC Rules. 

These limits are designed to provide reasonable protection against 

harmful interference in a residential installation. This equipment 

generates, uses and can radiate radio frequency energy and, if not 

installed and used in accordance with the instructions, may cause 

harmful interference to radio communications. However, there is no 

guarantee that interference will not occur in a particular installation. If 

this equipment does cause harmful interference to radio or television 

reception, which can be determined by turning the equipment off and 

on, the user is encouraged to try to correct the interference by one or 

more of the following measures:

   Reorient or relocate the receiving antenna.

   Increase the separation between the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject 

to the following two conditions: (1) this device may not cause harmful 

interference, and (2) this device must accept any interference received, 

including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party 

responsible for compliance could void the user’s authority to operate 

the equipment.

For European Union

For USA

QUICCO SOUND Corporation hereby declares that this WIRELESS MIDI 

INTERFACE  mi.1 is in compliance with the essential requirements and other 

relevant provisions of Directive 1999/5/EC and 2011/65/EU.

This statement has to be accompanied by the exact address 

(http://www.quicco.co.jp/support-mi1) where a copy of the original 

declaration of conformity may be found or obtained.

For information about product warranty, returns or 

troubleshooting, please see the URL below.

http://www.quicco.co.jp/support-mi1

Crestec Europe B.V  

110 Teleportboulevard, 1043 EJ, Amsterdam, The Netherlands

QUICCO SOUND Corporation

B-2  3-3-1, Shinmiyakoda 1-chome, Kita-ku Hamamatsu  

431-2103 Japan

NF00120  

Be sure to read and follow the directions of the cautions described below to 

prevent electric shocks, fires, injuries and malfunctions.

Safety Precautions



 Do not use this product for uses other than its intended use.



 Stop using this product immediately if it generates heat, smoke 

or odors, or if there are any other abnormalities.



 Stop using this product immediately if it is damaged.



 Do not disassemble, alter or repair this product by yourself.

Please follow the instruction that can be 

found online at:

http://www.quicco.co.jp/mi1-update

Connection between iPhone/iPad is made by using Bluetooth 

MIDI-enabled applications such as GarageBand. For connection 

between Mac, go to Application/Utilities folder and open Audio 

MIDI Setup. For details please visit our website.

Factory-default version of firmware is V2.

http://www.quicco.co.jp/how-to-connect-mi1v2

Piano Jukebox

This transmitter must not be co-located or operated in conjunction 

with any other antenna or transmitter.

This equipment complies with FCC radiation exposure limits set forth 

for an uncontrolled environment and meets the FCC radio frequency 

(RF) Exposure Guidelines. This equipment has very low levels of RF 

energy that are deemed to comply without testing of specific 

absorption rate(SAR).

Wireless Precautions

MIDI

IN

OUT