Extron Electronics EXTWAP100AC 用户手册
Installation
Overview
This section contains an overview of the installation process. Follow the links for a more
detailed explanation of each step.
detailed explanation of each step.
1.
Before starting, determine where to mount the WAP 100AC for optimal performance,
consider factors that can affect signal strength (see Before you Start in the Mounting
section on page 13).
consider factors that can affect signal strength (see Before you Start in the Mounting
section on page 13).
2.
Obtain the following network information from your network administrator:
Dynamic Host Configuration Protocol (DHCP) status (on or off). If DHCP is off, you
will also require:
IP address
Subnet mask
Gateway
User name
— by default this is
admin
.
Passwords
— by default this is
extron
.
MAC address
— make a note of the touchpanel MAC address, which can be
found from the WAP 100AC internal Web page.
3.
Mount and cable the units:
Mount the units (see
Mounting
on page 13).
NOTE:
Prepare the mounting site but do not install the WAP 100AC until power
and network connections have been made.
ATTENTION:
•
Do not power on the WAP 100AC until you have read the Attention notice
on
on
page 6
(power injector) or on
page 7
(12 VDC power supply).
•
Ne branchez pas le WAP 100AC avant d’avoir lu les mises en garde
page 6
(injecteur PoE) ou
page 7
(source d’alimentation 12 VCC).
Connect the network cable to the WAP 100AC. If you are using Power over
Ethernet (PoE), see LAN/PoE input on page 5.
Extron recommends using Power over Ethernet (PoE). If you are not using Power
over Ethernet, see
12V Power Input
on page 7).
4.
Configure the WAP 100AC for Network Communication:
Connect the PC that you are using for setup to the same Ethernet subnetwork as
the WAP 100AC.
Use the WAP 100AC internal Web pages to configure the unit (see page 9).
WAP 100AC • Installation Overview
3