Wireless Engineering Ltd Co. SB-850-1900 用户手册

下载
页码 7
To have our engineers recommend the best system configuration for you, simply 
email us at support@wireng.com with as many details as possible about the 
structure where you need coverage, and we'll be pleased to assist you.
Installing Your System
The location of the Donor (external) antenna is critical because its path should 
not encompass the service antenna(s), hence, the Donor antenna optimal 
location will almost always be on a corner of the roof (or if the outside signal is 
not too weak, on one of the outside walls). If installation on an external antenna 
is difficult or undesired, you may use a directional window antenna such as the 
WinAerial™, but only if there is a window in the structure that is in the direction 
of the service provider(s) tower(s).
Once the Donor antenna has been installed, simply choose an indoor place for 
the sohoBoost™ (near a power outlet), run the appropriate coaxial cable to it, 
and connect it to the Donor Antenna port, either directly or through the 
LightningPro™ for lightning strikes protection (highly recommended). DO NOT 
POWER ON THE UNIT JUST YET.
The sohoBoost™ comes with the WideAnt-X™ as the Donor antenna, and the 
DomeAnt-Alpha™ as the Coverage antenna. The two included ultra-low loss 
coaxial cables lengths are 50 feet (for the Donor antenna) and 25 feet (for the 
Coverage antenna).
As far as Service/Coverage antennas, it's always recommended to use at least 
two of them, unless your space is quite small. In general, we recommend one 
Coverage antenna for each 2,000 square feet of contiguous space. Simply keep 
in mind that, the more Coverage antennas you have, the better the coverage. 
Notice that you can connect up to eight Coverage antennas to one sohoBoost™ 
(via one EMSplit™ and two EMSplit4™), but you can keep adding more and 
more Coverage antennas by inserting additional sohoBoost™ units with the 
W2I™ inline converter option without limits on the size of the structure you 
need to cover.
As far as the coaxial cables for both the Donor antenna and the Coverage 
antenna(s), it is highly recommended that you use the WIR400™ Ultra-Low Loss 
coaxial cable type (unless the distance between the antennas is very small, such 
as 15 feet or so, in which case you may use the WIR195™ or WIR200™ low-loss 
types).
Once the Coverage antenna(s) is/are installed, simply connect their cables to 
the sohoBoost™ Coverage port (or to the EMSplit™ in case of multiple antennas) 
and power on the unit. If the LIMIT red light is lit, you must change the 
orientation of the antennas or increase the distance between them, as the unit 
detected intersecting radiation patter between the Donor and Coverage 
antennas. In such cases where the antennas' orientation cannot be changed 
(i.e., when using omni directional antennas) or where the space is very small, 
you must add one or more WBSA™ (Wide Band Signal Attenuator) to either or 
both sohoBoost™ ports, to limit it's power and range.
SohoBoost™ by WirEng® - Copyright © 2015 WirEng® - All Rights Reserved – Patent Pending