dormakaba Canada Inc. RB103 用户手册

1. Remove power to the unit prior to installing the remote                       

receiver. (Fig.1)

2. Insert the pins of the remote board into the header of the button 

as indicated below. Ensure the pins are aligned and fully engaged in 

the header. (Fig.2)

3. Reapply power to the unit.

4.Once installed the transmitter and receiver must be paired to each 

other for proper operation.

R03-18TG-4

IS910TC-WRM-WRB

The remote module allows wireless activation of the 910TC button for convenience or installations that do not allow for wire access.

5. On the back of the remote board, locate the button and LED as 

indicated below. (Fig.3)

6. Press and hold the button on the board until the red LED comes 

on, then release.

7. While the LED is lit press the button on the transmitter (Fig. 4), 

the LED will blink indicating the code is being stored.

8. The red LED will go out to indicate the storing of the code has 

been successful. Up to 5 transmitters can be paired with one 

receiver by following the above process.  NOTE: Should you need to 

reprogram or delete a transmitter, all transmitters will be erased and 

need to be reprogrammed individually.

9. To erase all units, press and hold the button on the back of the 

board until the red LED comes on. Continue to hold the button until 

the LED goes out.

10. Repeat steps 6-8 to reprogram 

       © 2018 dormakaba Canada Inc.

        www.rutherfordcontrols.com • Phone: 1.800.265.6630 • Fax: 1.800.482.9795 • Email: sales_RCI@dormakaba.com

Fig. 1

Fig. 2

Fig. 4

Fig. 3

910TC-WRB