Dr. Mach GmbH & Co.KG 9005010029 用户手册
Mach-Wireless-SRC
Dr. Mach
Lamps + technology
59591210 Description – Mach-Wireless-SRC
26.05.2015 / Ed.01 / Die; Page 1
User Manual
Index
1.
General information .................................................................................................... 1
2.
Hardware: ................................................................................................................... 1
2.1.
Connection.............................................................................................................. 1
2.2.
Settings................................................................................................................... 1
2.3.
Assembly Diagramm ............................................................................................... 2
2.4.
Example for linking-up............................................................................................. 2
3.
User Information ......................................................................................................... 3
4.
Operational Description............................................................................................... 4
1. General information
The radio unit Mach-Wireless-SRC enables the operation of existing OT-lights from Dr.Mach
GmbH & Co. KG in a wireless mode. The correct functioning of the wireless operation requires
one radio unit installed in the light and a second radio unit installed inside the wall control
housing.
GmbH & Co. KG in a wireless mode. The correct functioning of the wireless operation requires
one radio unit installed in the light and a second radio unit installed inside the wall control
housing.
2. Hardware:
2.1. Connection
The radio unit consists of one radio board 67150216 and one radio module 67150215. The
radio module is connected to the plug J3 on the radio board. The radio board must be
connected to the I2C bus with the 4-pole JST-connectors (CN1 and CN2) between the main
control and the key pad. These connectors are assigned with the power supply +5V (Pin1,
Pin4) and with one I2C – interface (Pin2 , Pin3).
radio module is connected to the plug J3 on the radio board. The radio board must be
connected to the I2C bus with the 4-pole JST-connectors (CN1 and CN2) between the main
control and the key pad. These connectors are assigned with the power supply +5V (Pin1,
Pin4) and with one I2C – interface (Pin2 , Pin3).
2.2. Settings
The setting of the WCom-Unit is done with dip-switch S1. The WCom-Unit is designed to
enable communication only between lights (radio units) with the same WCom-Unit.
Settings can be done for a maximum number of 16 different WCom-Unit’s.
Dip – Switch S1 (WCom – Unit)
enable communication only between lights (radio units) with the same WCom-Unit.
Settings can be done for a maximum number of 16 different WCom-Unit’s.
Dip – Switch S1 (WCom – Unit)
1
2
3
4
WCom-
Unit
Off
Off
Off Off
1
On
Off
Off Off
2
Off
On
Off Off
3
On
On
Off Off
4
Off
Off
On
Off
5
On
Off
On
Off
6
Off
On
On
Off
7
On
On
On
Off
8
Off
Off
Off
On
9
On
Off
Off
On
10
Off
On
Off
On
11
On
On
Off
On
12
Off
Off
On
On
13
On
Off
On
On
14
Off
On
On
On
15
On
On
On
On
16