WaveLynx Technologies Corporation WLTC-ET10-1357 用户手册
www.wavelynxtech.com | 100 Technology Drive, Suite 150B, Broomfield CO, 80021 | 720-572-4963
Wall Mounted Reader Installation
This installation guide applies to the following types of readers:
•
ET10 – Mullion Reader
Included:
•
(2) #6 Screws
•
Reader, Backplate, and Wall Plate
•
(1) #4-40, (1) pin-in-torx
The Following tools will be needed to install
a wall mount reader:
•
Phillips Screwdriver
•
6-32 Tap (if installing on metal)
•
1” (25mm), 1/8” drill bits
•
T8 Security Torx Bit (optional for increased tamper
detection)
Common Cable Connections
Red
Power In
Black
Ground
Shield
Shield Ground
Brown*
Tamper Out
Green
Wiegand Data 0 /
RS 485A
White
Wiegand Data 1 /
RS 485B
Yellow*
Beeper Control
Blue*
Green LED Control
Orange* Red LED Control
Max Length to Panel
Length
AWG
200’ (60 m)
22
300’
20
500’
18
Current @ 12 V and 25 C
Avg. mA
Max. mA
100
160
3
Wire the Cable to the Control Panel
Attach the Reader to the
Wall plate
Align the reader so that the tabs of the base plate
slide into the slots on the wall plate and slide the
reader into position.
*these wires are only used in
Wiegand readers.
4
1
2
Mounting Holes for Wall Plate
Drill two mounting holes at a minimum of 1.7” apart.
Drill a ½” hole in the center for the pigtail wire to pass
through. Use the wall plate as a guide for drilling.
Install Metal Wall Plate
Once the holes are prepared, screw the wall plate in
using the provided #6 screws.
½” Hole for
Pigtail
Mounting hole
distance is
adjustable, use
the provided
#6 screws