Firelands Group LLC KNNS0005 用户手册

 

 

5. TH pull ahead in the end does not move, press the CH1 + .CH1- TH forward amplitude adjustment for 

addition, subtraction. 

 

6.

 

TH pull back in the end does not move, press the CH1 + .CH1- TH Back amplitude adjustment for addition, 

subtraction. 

 

7.

 CH3 for three-channel direction, click CH3, three-channel direction in the end does not move to the right, 

then click back into place CH3

 

 

8 .ST to the left or right end do not pull the  end, press  REV for  about 3 seconds for the ST direction and 

reverse adjustment. 

 

9. TH pulled forward or backward and not really the end, press REV for about 3 seconds for the TH direction 

and reverse adjustment. 

 

10. The transmitter is in static state about 10 minutes a buzzer rang enter a sleep mode, power indicator lamp. 

 

11. Battery warning mode, when the battery voltage is lower than 4.5V

f0.2, the buzzer discontinuity is called. 

 

12.  Setting out  of  control protection  mode, TH  pull forward or  backward in  the  end what real, press  CH4 for 

about 5 seconds 

a buzzer rang, loosen  the  CH4 about  1-2 seconds  and  then release  the  TH, the 

transmitter power switch off (transmitter in the energized state), forward or backward in the end what real. 

 

13.

 

The third mode switch in the 1 files, all normal function; the 2 files, ST/TH function is normal, can only 

be adjusted ST TRIM; file 3 adjustable ST TRIM and TH advance, only half. 

 

14. 

Hold down the reset wait 5 seconds after boot flash once, and clear the current memory beep, wait 5 

seconds and then continue to hold the rear lights flash twice and will beep twice, indicating restored to factory 

settings

 

 

 

Notice 

1. 

The  transmitter with out  of  control protection  function, when the signal is lost, the accelerator will 

automatically at a set position, please do not also pick out of control protection device. 

 

2. Into the function mode of operation, each press the clear buzzer rang. 

 

3.Function setting mode into DC6V

f0.1 voltage test. 

 

4. Steering angle indication: left, right, forward, backward each 45 ± 5 degrees , CH3, angle of 90 degrees to 

the right bit amplitude. 

 

 In sleep mode, the transmitter power off automatically, turn  off  the  power supply when  there  opening 
of use, function returned to normal use.