Xi'an NovaStar Tech Co. Ltd EMT200 用户手册

www.novastar.tech 

i 

Copyright © 

No part of this document may be copied, reproduced, extracted or transmitted in any form or by any means 

without the prior written consent of Xi’an NovaStar Tech Co., Ltd. 

is a trademar

k of Xi’an NovaStar Tech Co., Ltd. 

You are welcome to use the product of Xi’an NovaStar Tech Co., Ltd. (hereinafter referred to as NovaStar). 

This document is intended to help you understand and use the product. For accuracy and reliability, 
NovaStar may make improvements and/or changes to this document at any time and without notice. Any 
problem in use or any good suggestion, please contact us through ways provided in the document. We will 
do our utmost to solve the problems and adopt the suggestions after evaluation as soon as possible. 

Any Changes or modifications not expressly approved by the party responsible for compliance could void the 

user's   authority to operate the equipment.   

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) 

This device may not cause harmful interference, and (2) this device must accept any interference received, 
including interference that may cause undesired operation. 

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, 

pursuant to  part 15 of the FCC Rules. These limits are designed to provide reasonable protection against 
harmful interference in  a residential installation. This equipment generates, uses and can radiate radio 
frequency energy and, if not installed   and used in accordance with the instructions, may cause harmful 
interference to radio communications. However,  there is no guarantee that interference will not occur in a 
particular installation. If this equipment does cause harmful   interference to radio or television reception, 
which can be determined by turning the equipment off and on, the user is   encouraged to try to correct the 
interference by one or more of the following measures:    

—Reorient or relocate the receiving antenna. 

—Increase the separation between the equipment and receiver. 

—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 

—Consult the dealer or an experienced radio/TV technician for help.  

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.