The Watt Stopper Inc. d/b/a Qmotion DR20-908 用户手册

 6 

 

 
SETTING OPEN/CLOSE LIMIT  
1. Perform two Taps, short pause between them. 

 _ 

(Shade will move to home position, then perform a single jog) 

2. Now perform two Taps (pause between) and wait for 5 seconds. 

 _ 

(Shade will move to home position, then perform a single jog) 

3. Set desired CLOSED position. 
 

A. From Z-Wave Controller: 

 

 

1. Use On/Off controls to nudge the shade towards the desired close position 

 

B. Manually from shade: 

 

 

1. Roll shade to desired closed position 

     (Shade should remain at the set location) 
4. From the Z-Wave controller, select the device to calibrate. 
5. Command shade to a position that is NOT On or Off. 

__ 

(Shade will move to home position, then perform a single jog) 

6. Set desired OPEN position. 
 

A. From Z-Wave Controller: 

 

 

1. Use On/Off controls to nudge the shade towards the desired open position 

 

B. Manually from shade: 

 

 

1. Roll shade to desired open position 

     (Shade should remain at the set location) 
7. From the Z-Wave controller, select the device to calibrate. 
8. Command shade to a position that is NOT On or Off. 

__ 

(Shade will move to home position, then perform a double jog) 

 

Open/Close Position can be set after the first ADD of the device by using the calibration mode.  The triple jog action is an indi-
cation of failure and the process is aborted.  If the expected results differ or a failure is indicated, restart the calibration pro-
cess.