Quest Technical Sales and Marketing Inc. QTS0000LINK 用户手册
SCREENLOGIC
®
INTERFACE Wireless Connection Kit Installation Guide
2
Antenna location
Indoor Wireless Transceiver
PWR: Green LED on: Power is on to the unit.
• PWR LED blinking: Not linked or lost link,
attempting to link or relink, no response.
• PWR LED blinking, TX and/or RX LED blinking:
not linked, attempting to link, getting responses.
• PWR LED on steady: Linked.
• PWR LED blinking: Lost link, Attempting to relink.
RX: Yellow LED indicates the unit is receiving data.
TX: Green LED indicates the unit is transmitting data.
• PWR LED blinking: Not linked or lost link,
attempting to link or relink, no response.
• PWR LED blinking, TX and/or RX LED blinking:
not linked, attempting to link, getting responses.
• PWR LED on steady: Linked.
• PWR LED blinking: Lost link, Attempting to relink.
RX: Yellow LED indicates the unit is receiving data.
TX: Green LED indicates the unit is transmitting data.
Note: ScreenLogic Interface Indoor Wireless Transceiver (Note: For optimum
performance, mount indoor transceiver upright in the cradle or on an indoor
wall).
performance, mount indoor transceiver upright in the cradle or on an indoor
wall).
Summary Installation Steps
The ScreenLogic
®
Interface connection diagram on page 3 shows the
transceiver locations and connections. To install the ScreenLogic Interface
Wireless Connection kit:
Wireless Connection kit:
RS-485 Connector
(to Protocol Adapter)
•
Mount the outdoor transceiver antenna module near the IntelliTouch
®
or EasyTouch
®
Control System Load Center (see page 4 for
mounting instructions). Using the provided 10 ft. cable, connect the
transceiver to the COM port connector located in the IntelliTouch
transceiver to the COM port connector located in the IntelliTouch
or
EasyTouch
Control System Load Center (see page 7).
•
Connect the ScreenLogic Interface indoor wireless transceiver to the
ScreenLogic Interface Protocol adapter using the 12 in cable. Plug
the AC power adapter into an AC wall-outlet and into the wireless
transceiver unit to power up the unit (see page 8).
ScreenLogic Interface Protocol adapter using the 12 in cable. Plug
the AC power adapter into an AC wall-outlet and into the wireless
transceiver unit to power up the unit (see page 8).
ID number
(Outdoor transceiver)
(Outdoor transceiver)
IMPORTANT NOTICE: Be sure the
yellow ID label (9-digit ID number
XXXXXXXXX) located to the right of
the RS-485 connector on the front side
of the Indoor transceiver
enclosure and the ID number
on the ScreenLogic Interface Outdoor
Wireless transceiver are the same. See
page 1 for label location.
yellow ID label (9-digit ID number
XXXXXXXXX) located to the right of
the RS-485 connector on the front side
of the Indoor transceiver
enclosure and the ID number
on the ScreenLogic Interface Outdoor
Wireless transceiver are the same. See
page 1 for label location.
LED Indicators Description: