Petcube Inc. PB913NVTD 用户手册
Designed For Pet Parents
T R E AT R E CO M M E N DAT I O N S
STA R T G U I D E
I N STA L L AT I O N
Consider placing Petcube Bites in a location that
allows for maximum coverage through the camera’s
138° wide angle lens. It’s always a good idea
to point Petcube Bites in the direction where your
pet tends to spend most of their time.
allows for maximum coverage through the camera’s
138° wide angle lens. It’s always a good idea
to point Petcube Bites in the direction where your
pet tends to spend most of their time.
Treats should be uniform in size, no smaller
than 0.3 inches and no larger than 1 inch in
length. The treat hopper can fit up to 100 treats.
than 0.3 inches and no larger than 1 inch in
length. The treat hopper can fit up to 100 treats.
Treats must be dry and hard.
Treats should not be greasy, soft, sticky
or crumbly.
or crumbly.
Use treats that are all the same size and shape.
For smaller size treats, multiple treats may
be dispensed at once.
be dispensed at once.
Petcube Bites is integrated with Amazon Dash
Replenishment Service (DRS) to allow for
automatic treat refillment from Amazon when
supplies run low. Control this option through the
Petcube App and enjoy convenient reordering
and shipment of your treats from Amazon.
Replenishment Service (DRS) to allow for
automatic treat refillment from Amazon when
supplies run low. Control this option through the
Petcube App and enjoy convenient reordering
and shipment of your treats from Amazon.
Troubleshooting Tips
If a treat gets jammed in the container, you’ll
get a notification via the Petcube App. You can
dislodge the treat by removing it or shaking the
container to empty it. If a treat gets stuck in
the flinging mechanism, use the door on the
bottom of the device to remove it.
Do not unjam the device with sharp
instruments or apply too much pressure,
both of which can damage the device.
If a treat gets jammed in the container, you’ll
get a notification via the Petcube App. You can
dislodge the treat by removing it or shaking the
container to empty it. If a treat gets stuck in
the flinging mechanism, use the door on the
bottom of the device to remove it.
Do not unjam the device with sharp
instruments or apply too much pressure,
both of which can damage the device.
Close Container Lid
Securely close the lid for an airtight seal to keep
treats fresh and so no odors get out.
Securely close the lid for an airtight seal to keep
treats fresh and so no odors get out.
Detachable Treat Container
Detach the treat container by pushing the back
release button to the right and pulling up and
away from the base.
Detach the treat container by pushing the back
release button to the right and pulling up and
away from the base.
Cleaning Made Simple
The detachable treat container is dishwasher safe
on lower temperature/delicate cleaning settings
(up to 130’F), or you can wash it by hand.
Do not use abrasive cleaners on the container,
only liquid detergents and soft sponges.
The detachable treat container is dishwasher safe
on lower temperature/delicate cleaning settings
(up to 130’F), or you can wash it by hand.
Do not use abrasive cleaners on the container,
only liquid detergents and soft sponges.
If you want to place Petcube Bites on a table
or shelf, we recommend you set it up at least
3 feet above the floor. Petcube Bites has a non-slip
rubber bottom, which provides a secure grip on
flat surfaces. The camera should be placed closer
to the edge of the surface for better viewing angle.
or shelf, we recommend you set it up at least
3 feet above the floor. Petcube Bites has a non-slip
rubber bottom, which provides a secure grip on
flat surfaces. The camera should be placed closer
to the edge of the surface for better viewing angle.
If you decide to mount Petcube Bites securely
on the wall, select your preferred viewing height.
Then, use the included mounting guide to mark
where to drill holes (0.3 inch diameter for the
included dowels) and two anchor screws to affix
the device.
on the wall, select your preferred viewing height.
Then, use the included mounting guide to mark
where to drill holes (0.3 inch diameter for the
included dowels) and two anchor screws to affix
the device.
M A I N T E N A N C E
I N T H E B OX
Model:PB913NVTD
Petcube Bites