Roseman Engineering Ltd. 2288 用户手册
998 Old Eagle School Road, Suite 1215
|
Wayne, Pennsylvania 19087
|
T: 610-225-8350
|
F: 610.971.9447
|
www.assetworks.com
73
18
Fueling Options
•
Either SVID [Fuel Inlet Antenna Connector P/N RID-IN-54]
•
Or Hardwire [Fuel Intel Antenna Connector P/N RID-EM-02]
Both options also require a Fuel Intel Antenna [P/N RVC-XX –XX]
SVID Mounting and Installation
18.1.1
Mounting the Fuel Inlet Antenna (FIA)
Note
Use shielded cable type Olympic part # 2886 or equivalent, polypropylene
insulated, twisted pair, aluminum Mylar shield, 20 – 22 AWG stranded
tinned copper drain wire, chrome vinyl jacket. Temperature rating: -20ºC to
60ºC.
insulated, twisted pair, aluminum Mylar shield, 20 – 22 AWG stranded
tinned copper drain wire, chrome vinyl jacket. Temperature rating: -20ºC to
60ºC.
Connect the FIA coil before mounting, to avoid using the heat gun
near the fuel tank. Before making this connection, plan on where
you are going to mount the SVID. Then make sure you have
clearance to pass the SVID from the filler neck to the mounting
location.
near the fuel tank. Before making this connection, plan on where
you are going to mount the SVID. Then make sure you have
clearance to pass the SVID from the filler neck to the mounting
location.
If you do not have enough clearance, first position the FIA coil on
the vehicle. Then pull the wire out to a safe distance (at least three
feet from the fuel filler neck) to heat the shrink-wrap insulation.
Then pull the wire back for final mounting.
the vehicle. Then pull the wire out to a safe distance (at least three
feet from the fuel filler neck) to heat the shrink-wrap insulation.
Then pull the wire back for final mounting.
Select a Fuel Inlet Antenna (FIA) with an internal diameter that allows it to fit snugly over the
filler neck. (A variety of sizes are available from AssetWorks.) Slide the FIA down over the filler
neck and slide it back until it is securely in place. (See note)
The intrinsically safe FIA wires must be tie wrapped at various locations between the FIA and
the SVID. One tie will be placed on the FIA wire, directly behind the antenna, to prevent the
antenna from falling off the filler neck.
Note
The FIA must be placed no more than four inches from the filler neck
opening. If the exposed portion of the filler neck pipe is longer than four
inches, place a plastic tie behind the antenna to hold it in place. You may
now install the odometer adaptor (if required) according to the
manufacturer's instructions. Then proceed to "Mounting the SVID".
opening. If the exposed portion of the filler neck pipe is longer than four
inches, place a plastic tie behind the antenna to hold it in place. You may
now install the odometer adaptor (if required) according to the
manufacturer's instructions. Then proceed to "Mounting the SVID".