Dataram DRSX1333RL/4GB 产品宣传页
DRSX1333RL
DDR3-1333, PC3L-10600, Registered, ECC, 1.35V, 240-pin DIMMs
DRSX1333RL
16-Jun-11
Copyright
2011 Dataram Corporation | U.S.A. Headquarters +1 609-799-0071 | Offices in Europe and Asia | www.dataram.com
The information contained in this document has been carefully checked and is believed to be reliable and accurate. However, Dataram assumes no responsibility for errors.
Products in Family
DRSX1333RL/4GB (1 x 4GB 1Rx4 DIMM)
DRSX1333RL/8GB (1 x 8GB 2Rx4 DIMM)
DRSX1333RL/16GB (1 x 16GB 2Rx4 DIMM)
DRSX1333RL/8GB (1 x 8GB 2Rx4 DIMM)
DRSX1333RL/16GB (1 x 16GB 2Rx4 DIMM)
Features
Description
240-pin JEDEC-compliant DIMMs
133.35 mm wide by 30 mm high (1.181” x 5.25”)
Data Transfer Rate: 10.6 Gigabytes/sec
Operating Voltage: 1.35 V ±0.075 (1.5 V tolerant)
Fully RoHS Compliant
Thermal Sensor
133.35 mm wide by 30 mm high (1.181” x 5.25”)
Data Transfer Rate: 10.6 Gigabytes/sec
Operating Voltage: 1.35 V ±0.075 (1.5 V tolerant)
Fully RoHS Compliant
Thermal Sensor
Each DRSX1333RL upgrade consists of a single DDR3-
1333 Registered DIMM that conforms to JEDEC’s DDR3,
PC3L-10600 standard. One 2K-bit EEPROM is used for
Serial Presence Detect and a combination register/PLL
with Address and Command Parity is also used. A
thermal sensor accurately monitors the DIMM module
and can prevent exceeding the maximum operating
temperature of 95C.
1333 Registered DIMM that conforms to JEDEC’s DDR3,
PC3L-10600 standard. One 2K-bit EEPROM is used for
Serial Presence Detect and a combination register/PLL
with Address and Command Parity is also used. A
thermal sensor accurately monitors the DIMM module
and can prevent exceeding the maximum operating
temperature of 95C.
Dataram Product
Oracle / Sun Product
Supported in these Oracle / Sun systems:
DRSX1333RL/4GB
DRSX1333RL/8GB
DRSX1333RL/16GB
DRSX1333RL/8GB
DRSX1333RL/16GB
X4910A
X4911A
Not Offered by Oracle
X4911A
Not Offered by Oracle
Sun Fire X4170 M2, X4270 M2, Sun Blade X6270 M2
Notes
Tolerances on all dimensions
except where otherwise
indicated are ±.13 (.005).
except where otherwise
indicated are ±.13 (.005).
All dimensions are expressed
in millimeters [inches]
in millimeters [inches]