Philips Wireless HD AV Connect SWW1810 SWW1810/27 用户手册

10

5

  Extend and stick the IR sensor extender 

cable onto the front side of your HDTV.

Note

 

•

The IR blaster support 47KHz remote signal protocol, 

while the IR sensor supports 36KHz - 56KHz (NEC, 

RC5, RC6) remote signal protocol.

Install remote control 

batteries

Caution

 

•

Risk of explosion! Keep batteries away from heat, 

sunshine or fire. Never discard batteries in fire.

 

•

Risk of decreased battery life! Never mix different 

brands or types of batteries.

 

•

Risk of product damage! When the remote control is 

not used for long periods, remove the batteries.

AAA

AAA

  

1

  Open the battery compartment.

2

  Insert two AAA batteries with correct 

polarity (+/-) as indicated.

3

  Close the battery compartment.

Connect the IR blaster and IR 

sensor extender cables

Tip

 

•

If you cannot use the remote control of your device, 

follow the steps in this section to connect the sensor 

extender cables .

 

Connect the infrared blaster or sensor extender 

cables if necessary.

1

  Plug the IR blaster extender cable into 

the IR OUT blaster extender jack of the 

transmitter.

2

  Extend and stick the IR blaster extender 

cable onto the front panel of the HD 

device. 

3

  After the IR blaster extender cable is 

connected to the transmitter, you can 

control your HD device with the remote 

control. Make sure that the remote control 

points to the receiver.

4

  If the distance between the receiver and 

receiver has obstruction (e.g. the receiver 

is mounted at the back of the HDTV), plug 

the IR sensor extender cable into the IR 

IN jack of the receiver. 

EN