Asrock K7UPGRADE-880 用户手册

2 1

ATX 12V Connector

Please note that it is necessary

(4-pin ATX12V1)

to connect a power supply with

(see p.8, No. 6)

ATX 12V plug to this connector

so that it can provides sufficient

power. Failing to do so will cause

the failure to power up.

Power LED Header

Please connect a 3-pin power

(3-pin PWR_LED1)

LED cable to this header.

(see p.8 No. 23)

2.7

2.7 Serial A

Serial A

Serial ATTTTTA (SA

A (SA

A (SATTTTTA) Hard Disks Installation

A) Hard Disks Installation

This motherboard supports Serial ATA (SATA) hard disks and RAID functions. You

may install SATA hard disks on this motherboard for internal storage devices. This

section will guide you to install the SATA hard disks.

STEP 1: Install the SATA hard disks into the drive bays of your chassis.

STEP 2: Connect the SATA power cable to the SATA hard disk.

STEP 3: Connect one end of the SATA data cable to the motherboard’s SATA

connector.

STEP 4: Connect the other end of the SATA data cable to the SATA hard disk.

2.8

2.8 Hot Plug and Hot Swap F

Hot Plug and Hot Swap F

Hot Plug and Hot Swap Functions for SA

unctions for SA

unctions for SATTTTTA HDDs

A HDDs

K7Upgrade-880 motherboard supports Hot Plug and Hot Swap functions for

SATA Devices.

What is Hot Plug Function?

If the SATA HDDs are NOT set for RAID configuration, it is called “Hot

Plug” for the action to insert and remove the SATA HDDs while the

system is still power-on and in working condition. However, please note

that it cannot perform Hot Plug if the OS has been installed into the SATA

HDD.

What is Hot Swap Function?

If SATA HDDs are built as RAID1 then it is called “Hot Swap” for the

action to insert and remove the SATA HDDs while the system is still

power-on and in working condition.

PLED+

PLED-