Kingston Technology 24GB 1066MHz DDR3 ECC Reg CL7 DIMM (Kit of 3) QR, x8 w/TS KVR1066D3Q8R7SK3/2/4G 数据表

Document No. VALUERAM0857-001.A00

09/18/09

Page 1

ValueRAM's KVR1066D3Q8R7SK3/24G is a kit of three 1024M x 72-bit 8GB (8192MB) DDR3-1066 CL7 SDRAM
(Synchronous DRAM)  registered w/parity, quad-rank memory modules, based on thirty-six 256M x 8-bit DDR3-1066
FBGA components per module. Total kit capacity is 24GB. The SPDs are programmed to JEDEC standard latency
1066Mhz timing of 7-7-7 at 1.5V. Each 240-pin DIMM uses gold contact fingers and requires +1.5V. The electrical and
mechanical specifications are as follows:

JEDEC standard 1.5V ± 0.075V Power Supply

VDDQ = 1.5V ± 0.075V

533MHz fCK for 1066Mb/sec/pin

8 independent internal bank

Programmable CAS Latency: 6,7,8,9

Programmable Additive Latency: 0, CL - 2, or CL - 1 clock

Programmable CAS Write Latency(CWL) = 6(DDR3-1066)

8-bit pre-fetch

Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4

which does not allow seamless read or write [either on the fly using A12 or MRS]

Bi-directional Differential Data Strobe

Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%)

On Die Termination using ODT pin

On-DIMM thermal sensor (Grade B)

Average Refresh Period 7.8us at lower then TCASE 85°C, 3.9us at 85°C < TCASE . 95°C

Asynchronous Reset

PCB : Height 1.180” (30.00mm), double  sided  component

CL(IDD)

7 cycles

Row Cycle Time (tRCmin)

50.63ns (min.)

Refresh to Active/Refresh Command Time (tRFCmin)

160ns (min.)

Row Active Time (tRASmin)

37.5ns (min.)

Power

3.705 W (operating per module)

UL Rating

94 V - 0

Operating Temperature

0

o

 C to 85

o

 C

Storage Temperature

-55

o

 C to +100

o

 C