HP 120 G7 628691-001+481045-B2 用户手册

 

HP 8.6kVA 24A Single Input Three Phase Monitored Power Distribution Unit

AF504A

HP 8.3kVA 40A Single Input Single Phase Monitored Power Distribution Unit

AF506A

HP 4.9kVA 24A Single Input Single Phase Monitored Power Distribution Unit

AF914A

NOTE: 1U/0U mounting brackets shipped with the unit (optimized for 10000 and 9000
series racks).

 

HP 4.9kVA 24A High Voltage Modular Power Distribution Unit

252663-D72

HP 8.3kVA 40A High Voltage Modular Power Distribution Unit

252663-D73

NOTE: Please see the following Modular Power Distribution Unit (Zero-U/1U Modular
PDUs) QuickSpecs for additional options including shorter jumper cables and country
specific power cords:

NOTE: For additional information on HP Power Distribution Units including accessories
please go to: 

NOTE: Please see the UPS and PDU cable matrix's on the HP Power Protection and
Management page. Under Power Cords, click on the "HP Power Cord Matrix" link. That
link will list cable descriptions, requirements, and specifications for UPS and PDU units.
Please see the following link: 

.

 

HP 10642 G2 1200mm deep Shock Rack

AF092A

HP 10647 G2 1200mm deep Shock Rack

AF094A

HP 10642 G2 Shock Universal Rack

AF002A

NOTE: Please see the QuickSpecs for Technical Specifications and additional
information:

 

NOTE: For additional information regarding Rack Cabinets, please see the following
URL: 

 

NOTE: The increasing power of new high-performance processor technology requires
increased cooling efficiency for rack-mounted servers. The 10000 G2 Series Racks
provide enhanced airflow for maximum cooling, allowing these racks to be fully loaded
with servers using the latest processors.

CAUTION: If a third-party rack is used, observe the following additional requirements to
ensure adequate airflow and to prevent damage to the equipment:

Front and rear doors: If your 42U server rack includes closing front and rear
doors, you must allow 830 square inches (5,350 sq cm) of hole evenly distributed
from top to bottom to permit adequate airflow (equivalent to the required 64
percent open area for ventilation).
Side: The clearance between the installed rack component and the side panels of
the rack must be a minimum of 2.75 inches (7 cm).

CAUTION: Always use blanking panels to fill all remaining empty front panel U-spaces in

 

DA - 14009   North America — Version 17 — May 17, 2012

Page  26