AMX FG2105-70 产品宣传页
N I - 7 0 0
D ATA S H E E T
3000 RESEARCH DRIVE, RICHARDSON, TX 75082 • 800.222.0193 • 469.624.8000 • +1.469.624.7400 • 469.624.7153 fax • www.amx.com
5 9/16”
(14.1 cm)
5 1/8”
(13 cm)
1 9/16”
(4 cm)
NI-700 (Front View)
NI-700 (Back View)
NI-700 (Left View)
NI-700 (Top View)
NI-700 (FG2105-70)
DIMENSIONS (HWD)
•
1 9/16” x 5 9/16” x 5 1/8” (4.01 cm x 14.10 cm x 13.00 cm)
•
RU: 1
WEIGHT
1.30 lbs (590 g)
POWER
•
280 mA @ 12 VDC
•
Power requirements are usage dependant
ENCLOSURE
Metal with black matte finish
ONBOARD MASTER
304 MIPS
CERTIFICATIONS
FCC Part 15 Class B, CE, and IEC 60950
FRONT PANEL COMPONENTS:
•
Program Port
•
Configuration DIP Switch: Sets the communication parameters for the
Program port
•
IR RX LED: Red LED lights when IR data is being received via the rear IR RX port
•
IR LED: Red LED lights during the transmission of IR or Serial data via the rear
IR port
•
I/O LEDs: Four yellow LEDs light when the rear I/O channels 1 - 4 are active. LED
indicator for each I/O port reflects the state of that particular port
•
Serial LEDs
•
LINK/ACT: Green LED lights when the Ethernet cable is connected and an active
link is established. This LED also blinks when receiving Ethernet data packets
•
Status: Green LED lights when the Controller is programmed and communicating
properly
•
Output: Red LED lights when the Controller transmits data, sets channels sends
data strings, etc.
•
Input: Yellow LED lights when the Controller receives data from button pushes,
strings, commands, channel levels, etc.
•
ID Pushbutton: Sets the NetLinx ID (Device only) assignment for the device
REAR PANEL COMPONENTS
•
RS-232/422/485 (Ports 1 & 2)
•
IR RX (Port 5)
•
Digital I/O (Port 4)
•
IR/Serial (Port 3)
•
AxLink LED
•
AxLink Port: 4-pin 3.5 mm mini-Phoenix (male) connector provides data and power
to external control devices
•
Ethernet Port: RJ-45 port for 10/100 Mbps communication. LEDs show
communication activity, connection status, speeds, and mode information: - SPD
(speed) - Yellow LED lights On when the connection speed is 100 Mbps and turns
Off when the speed is 10 Mbps. - L/A (link/activity) - Green LED lights On when
the Ethernet cables are connected and terminated correctly, and blinks when
receiving Ethernet data packets.
(speed) - Yellow LED lights On when the connection speed is 100 Mbps and turns
Off when the speed is 10 Mbps. - L/A (link/activity) - Green LED lights On when
the Ethernet cables are connected and terminated correctly, and blinks when
receiving Ethernet data packets.
•
Power Port
ENVIRONMENTAL
•
Operating Temperature: 0° C (32° F) to 50° C (122° F)
•
Operating Humidity: 20% to 85% RH
•
Heat Dissipation (Typical): 11.5 BTU/hr
INCLUDED ACCESSORIES
•
2-pin 3.5 mm mini-Phoenix female PWR connector (41-5025)
•
4-pin 3.5 mm mini-Phoenix female connector (41-5047)
•
6-pin 3.5 mm mini-Phoenix female I/O connector (41-5063)
•
CC-NIRC IR Emitter
RECOMMENDED ACCESSORIES
•
PSN6.5 - 6.5 A Power Supply (F423-41)
•
PSN4.4 - 4.4 A Power Supply (F423-45)
•
AC-RK - Accessory Rack Kit (FG515)
•
AC-SMB - Surface Mounting Bracket (FG525)
•
AC-PMB - Pole Mounting Bracket (FG531)
•
CC-232 - RS-232/422 Cables (FG10-752-04)
•
CC-NIRC - IR Cables (FG10-000-11)