Intel R1304BTLSFANR 用户手册
Intel
®
Server System R1304BTSSFAN/R1304BTLSFAN/R1304BTLSHBN TPS
350W Power Subsystem
Revision 2.1
21
Intel order number G17455-005
Notes:
1. Maximum input current at low input voltage range should be measured at 90 VAC at max load.
2. Maximum input current at high input voltage range should be measured at 180 VAC at max load.
2. Maximum input current at high input voltage range should be measured at 180 VAC at max load.
4.7 Output Power/Currents
The following tables define two power and current ratings for this 350-W power supply. The
combined output power of all outputs should not exceed the rated output power. The power
supply must meet both static and dynamic voltage regulation requirements for the minimum
loading conditions.
combined output power of all outputs should not exceed the rated output power. The power
supply must meet both static and dynamic voltage regulation requirements for the minimum
loading conditions.
Table 22. Load Ratings
Voltage
Minimum
Maximum
Output Power
+3.3 V
0.1 A
10 A
33W
+5 V
0.1 A
16 A
80W
+12 V1
0.75 A
18 A
216W
+12 V2
0.75 A
18 A
216W
-12 V
0 A
0.5 A
6W
+5 VSB
0.05 A
2.5 A
12.5W
Notes:
1. The total current of +12V1/2 will not exceed 28A.
2. The total output for this PSU is 350W.
3. The total output of +3.3V&+5V will not exceed 100W.
2. The total output for this PSU is 350W.
3. The total output of +3.3V&+5V will not exceed 100W.
4.8 Protection Circuits
Protection circuits inside the power supply should
cause only the power supply’s main outputs
to shut down. If the power supply latches off due to a protection circuit tripping, an AC cycle
OFF for 15sec min (with +5VSB/0.1A) and a PSON# cycle HIGH for 1sec shall be able to reset
the power supply.
OFF for 15sec min (with +5VSB/0.1A) and a PSON# cycle HIGH for 1sec shall be able to reset
the power supply.
4.8.1
Over Current Protection (OCP)
Each output shall have individual OCP protection circuits. The PSU shall shutdown and latch off
after an over current condition occurs. Whereas OCP of +5VSB shall turn the power supply into
“hiccup mode” until the OCP condition removed. The values are measured at the PSU harness
connectors and shall not be damaged from repeated power cycling in this condition. There shall
be current sensors and limit circuits to shut down the entire power supply if the limit is
exceeded. The limits are listed below.
after an over current condition occurs. Whereas OCP of +5VSB shall turn the power supply into
“hiccup mode” until the OCP condition removed. The values are measured at the PSU harness
connectors and shall not be damaged from repeated power cycling in this condition. There shall
be current sensors and limit circuits to shut down the entire power supply if the limit is
exceeded. The limits are listed below.
Table 23. Over Load Protection (OCP) Limits
Output Voltage
Continuous Load
Current Limit Min.
Current Limit Max.
+12V1
18.2A
20A
+12V2
18.2A
20A
+5V
19.2A
24A
+3.3V
12A
15A
-12V
4A
+5VSB
4.5A