Intel SC5299UP SC5299UPNA 用户手册
产品代码
SC5299UPNA
Intel
®
Entry Server Chassis SC5299-E TPS
Power Sub-system
Revision 3.1
Intel order number D37594-005
89
Table 109. P13 SATA Power Connector
Pin
Signal
18 AWG Color
1 +3.3V
Orange
2 COM
Black
3 +5VDC
Red
4 COM
Black
5 +12V4
Green
2.5.7
AC Input Requirements
2.5.7.1
Power Factor Correction
The power supply incorporates a power factor correction circuit.
The power supply is tested as described in EN 61000-3-2: Electromagnetic Compatibility (EMC
Part 3: Limits – Section 2: “Limits for harmonic current emissions,” and meets the harmonic
current emissions limits specified for ITE equipment.
Part 3: Limits – Section 2: “Limits for harmonic current emissions,” and meets the harmonic
current emissions limits specified for ITE equipment.
The power supply is tested as described in JEIDA MITI Guideline for Suppression of High
Harmonics in Appliances and General-Use Equipment, and meets the harmonic current
emissions limits specified for ITE equipment.
Harmonics in Appliances and General-Use Equipment, and meets the harmonic current
emissions limits specified for ITE equipment.
2.5.7.2
AC Input Connector
The AC input connector is an IEC 320 C-14 power inlet. This inlet is rated for 15A/250VAC.
2.5.7.3
AC Input Voltage Specification
The power supply operates within all specified limits over the input voltage range shown in the
following table. Harmonic distortion of up to 10% of the rated line voltage must not cause the
power supply to go out of specified limits. The power supply does power off if the AC input is
less than 75VAC +/-5VAC range. The power supply starts up if the AC input is greater than
85VAC +/-4VAC. Application of an input voltage below 85VAC does not cause damage to the
power supply, including a fuse blow.
following table. Harmonic distortion of up to 10% of the rated line voltage must not cause the
power supply to go out of specified limits. The power supply does power off if the AC input is
less than 75VAC +/-5VAC range. The power supply starts up if the AC input is greater than
85VAC +/-4VAC. Application of an input voltage below 85VAC does not cause damage to the
power supply, including a fuse blow.