Toshiba SST6200 用户手册

 

 WITH THE AMPLIFIER

SWITCH 

 

 TO STANDBY 

 OR 

 ANY 

1. If one of your speakers does not operate, follow this procedure:

a) switch the amplifier to STANDBY 

 

b) check that both speaker wires are 

 connected to binding posts in terminal cup of

speaker.

c) check that both speaker wires are. 

 connected to binding posts on back panel of

amplifier.

d) check all interconnects/patch cords to ensure that they ate 

 connected.

e) check the identification labels on 

 back panel of the amplifier to ensure that the speaker

is connected to the appropriate binding post.

 check that the Center Channel select switch is set correctly for your application, i.e.,

“I Only” for one center channel speaker, or “I and II” for two center channel speakers.

g) switch the amplifier to ON and play the speakers to ensure all units are operating.

2. If the total sound output seems 

 the phase of one or more speakers may be. reversed at

the wiring connections. Listen to each speaker individually and, if any unit is out-of-phase, it will
produce sonic information that 

 not seem to have an point of origin. Switch the amplifier to

STANDBY (or 

 and check to ensure that the marked wire connects to the positive (red and

red banded) binding posts of amp and speaker, and that the unmarked wire connects to the

negative (black and black 

 posts of amp and speaker.

3. If you are using the Toshiba XB-2000 surmund-sound amplifier, select the “Test Tones” output

of the amplifier GUI setup procedure to ensure each speaker is connected to the correct binding
posts. Refer to the applicable operating instructions for any other amplifier.

4. If these procedures do not 

 the problem that you are experiencing, call the Toshiba

Customer Support Center at 

 and speak with a customer service agent.