Troy-Bilt 2690XP 用户手册

Refer to the Engine Operator’s Manual.

The shave plate and skid shoes on the bottom of the snow 

thrower are subject to wear. They should be checked periodically 

and replaced when necessary.
NOTE: Deluxe skid shoes (on select models) have two wear 

edges. When one side wears out, they can be rotated 180° to use 

the other edge.
To remove skid shoes:
1. 

Remove the four carriage bolts and hex flange nuts which 

secure them to the snow thrower.

2. 

Reassemble new skid shoes with the four carriage bolts 

(two on each side) and hex flange nuts. Refer to Figure 6-1.

NOTE: Augers not shown for clarity

To remove shave plate:
1. 

Remove the carriage bolts and hex nuts which attach it to 

the auger housing.

2. 

Reassemble new shave plate, making sure heads of carriage 

bolts are to the inside of housing. Tighten securely.

The gear (hex) shaft should be lubricated at least once a season 

or after every twenty-five (25) hours of operation.
1. 

Allow the engine to run until it is out of fuel.

2. 

Carefully pivot the snow thrower up and forward so that it 

rests on the auger housing. 

3. 

Remove the frame cover from the underside of the snow 

thrower by removing the self-tapping screws which secure 

it. Refer to Figure 7-3 on page 19.

4. 

Apply a light coating of Anti-Sieze Regular Grade NS-42B to 

the hex shaft. See Figure 6-2.

NOTE: When lubricating the hex shaft, be careful not to get 

any anti-seize on the aluminum drive plate or the rubber 

friction wheel. Doing so will hinder the snow thrower’s 

drive system.

At least once a season, remove the shear pins from the auger 

shaft. Spray lubricant inside the shaft and around the spacers and 

the flange bearings found at either end of the shaft. See Figure 

6-3.