Britax Roundabout 用户手册

Using the Versa-Tether

Consult your vehicle owner’s manual for

approved tether-anchorage locations.

Locate the tether on the rear of the child

seat and remove the tether components

from the pouch. Place the tether up and

over the child seat back.

Install the child seat using the LATCH

system or the vehicle belts based on the

instructions in this manual.

Lift the tether release tab; then pull to fully

extend the tether strap into a “V” shape.

Locate the hook on the strap and loosely

attach the tether to an anchor point.

See figure A for forward-facing installation.

See figures B and C for rear-facing installations.

Secure the child seat by a seat-belt OR

with the LATCH connectors.

Pull the tether adjuster strap to remove all

slack.

Verify there is tension in the tether strap

and that the child seat is properly secured.

The child seat is secure when it cannot be moved

front-to-back or side-to-side more than 1 inch

(2.5 cm.) at the belt path.

NOTE:

The rear-facing recline angle of the child seat

should be 30º– 45º from vertical (not to exceed 45º) when car is parked

on a level surface (Figs. B and C).

The rear-facing recline angle can be adjusted by placing a rolled towel or

pool noodle in the crease of the vehicle seat.

•

Installation: Versa-Tether

Tether Connector Strap

WARNING!

Only use the tether connector strap for rear-

facing tether installation.

Because every vehicle model is different,

sometimes you cannot find a location to

properly anchor the tether or the structural

part of the seat is too large for the hook.

Use the tether connector strap to assist in

creating an anchor point (Fig. D).

Find a fixed vehicle seat belt anchor or

vehicle seat leg (that is bolted to the

floor) to which the strap can be wrapped

around.

If you cannot find an acceptable location to create an anchor

point, contact the vehicle manufacturer to identify a suitable

tether connection point.

Loop the strap around the metal anchor.

Take the metal D-ring and thread it through the webbing loop

on the other end of the strap.

Pull the metal D-ring all the way through until the strap is tight

around the metal anchor.

Use the D-ring as an attachment point for hook on tether

strap.