Husqvarna 1827SB 用户手册

6

INSTALL AUGER CONTROL ROD (See Figs. 5 and 6)
1.   Retrieve vinyl sleeve and spring from bag of parts and 

retrieve the auger control rod from carton chute tray.  

Slide straight rod end through the small hole in the 

vinyl sleeve. Hook spring in hole in rod end.

2.  Hook end of spring into control arm with loop opening 

up as shown. (See Fig. 5)

3.  With top end of rod positioned under right side of 

control panel, push down on rod and insert end of rod 

into hole in auger control bracket.  Secure with retainer 

spring.

HEAD (See Fig. 7)
NOTE: The multi-wrench provided in your parts bag may 

be used to install the chute rotator head.
1.  Place discharge chute assembly on top of chute base 

with discharge opening toward front of snow thrower.

2.  Position chute rotator head over chute bracket.  If nec es-

 sary, rotate chute assembly to align square and pin on un-

 der side of chute rotator head with holes in chute brack et.

3.  With chute rotator head and chute bracket aligned, 

po si tion chute rotator head on pin and threaded stud 

of mounting bracket.

4.  Install 3/8 washer and locknut on threaded stud and 

tighten securely.

CHECK TIRE PRESSURE
The tires on your snow thrower were overinflated at the fac-

tory for shipping purposes.  Correct and equal tire pres sure 

is important for best snow throwing performance.
•  Reduce tire pressure to 14-17 PSI.

Get user manuals: 

See SafeManuals.com