Lifebreath 60DHWDF(T) 用户手册

29

The Clean Air Furnace operates at 120V, singles
phase and draws anywhere from 2-8.7 amps, 
depending on fan speed.

The low voltage thermostat (not provided) 
connects to the R & W terminals for heating and
the R & Y & C terminals when calling for cooling. 

Caution should be used if installing a setback
thermostat to control the system. If the 
thermostat is set back too far, and, for example,
is set to call for a lot of heat when you get out of
bed, at which time showering and general water
use is at its peak, then the hot water heater may
not keep up.

To change fan speed, move 

bottom wires on the speed

select terminal block to the high,

med-hi or med location.

R - W

= Heat

R - G

= Fan Only (optional dehumidistat)

G - R - Y - C

= A/C