Roberts Gorden Caribe CGTH-30 用户手册
SECTION 4: I
NSTALLATION
17
4.7 Hang the Heater
Residential garages come in a variety of sizes,
shapes, styles and methods of construction.
Because of all these variables, it is not possible to
include mounting hardware with the CGTH-Series
heater. Although wooden rafters and joists are the
most common overhead structural members in resi-
dential garage applications, other structural configu-
rations are also illustrated below.
shapes, styles and methods of construction.
Because of all these variables, it is not possible to
include mounting hardware with the CGTH-Series
heater. Although wooden rafters and joists are the
most common overhead structural members in resi-
dential garage applications, other structural configu-
rations are also illustrated below.
In the typical suspension methods shown in Figure 7,
lengths of chain are shown as a means of lowering
the heater.
lengths of chain are shown as a means of lowering
the heater.
Whichever method of suspension is selected, the
three required suspension points must be capable of
supporting a minimum of 75 lbs. (33 kg) each.
three required suspension points must be capable of
supporting a minimum of 75 lbs. (33 kg) each.
4.8 Remove Shipping Screw from Control
Housing Door
Housing Door
The blower inside the burner box has a shipping
screw installed to protect the blower from damage in
shipping. Before hanging or operating heater, remove
the shipping screw and paper label from the control
housing door, see Figure 6. A nylon washer inside
the control housing will fall loose. It is not mandatory
to remove the washer from the control housing.
screw installed to protect the blower from damage in
shipping. Before hanging or operating heater, remove
the shipping screw and paper label from the control
housing door, see Figure 6. A nylon washer inside
the control housing will fall loose. It is not mandatory
to remove the washer from the control housing.
FIGURE 6: Shipping Screw
FIGURE 7: Suspension Details
4.9 Heater Assembly
• Slide rear movable hanger onto reflector as
shown in Figure 8.
• Attach reflector end cap with U-Clips as shown in
Figure 8.
FIGURE 8: Heater Assembly
WARNING
Suspension Hazard
Hang heater with materials with a
minimum working load of 75 lbs
(33 kg).
Failure of the supports can result
in death, injury or property
damage.
Shipping Screw
and Label
ATTENTION
Remove shipping scre
w before
heater instr
allation or use
. After
removing scre
w, discard the
screw and this label.
Remove scre
w
before use
.
ATTENTION
Retirez la vis de
xpédition a
vant
linstallation ou lutilisation du
chauffage. Après a
voir retiré la
vis, jetez la et jetez
cette étiquette
.
Retirez la vis
avant l'utilisation.
www.rg-inc
.com
Imprimé ou U
.S.A.
P/N 9103
7400
www.rg-inc
.com
Printed in the U
.S.A.
P/N 9103
7400
I-Beam
Beam Clamp
Snap
Hook
Anchor
Concrete Beam
Locknut
Washer
Screw Hook
min. 3/8" (10mm)
Wood Beam
As required
Wood Beam
Wood Screw
Thread Wire
Eye Bolt
Most common for
residential applications
Most common for
non-residential applications
Snap
Hook
Rear Movable
Hanger
Reflector
End Cap
4 U-Clips
Get user manuals:
See SafeManuals.com