Roland VS-1680 用户手册
20
Editing an automix
fig.4-05_80
Target
This will indicate the type of automix data that you selected
to be erased in step 6. If you wish to erase all automix data,
use the TIME/VALUE dial to select “All Level and Pan.”
10. If you wish to erase the data, press [F4 (Exec)]. If you
press [F6 (EXIT)], you will return to step 7 without
erasing any data.
11. A message will ask you to confirm the operation. Press
[YES]. If you press [NO], the erasure will be halted, and
you will return to step 10.
fig.4-06
12. When the data has been erased, the display will indicate
“Complete.” Press [PLAY (DISPLAY)].
Copying data to another
location (Copy)
location (Copy)
This operation copies automix data from a specific area, and
overwrites it onto another location (specified data/time).
fig.4-07.e
NOTE
Editing of the automix data cannot be cancelled by the Undo
function (VS-1680 Owner’s Manual, p. 160).
1. Press [PLAY (DISPLAY)].
2. Hold down [SHIFT] and press [F6 (UTIL)].
3. Press [PAGE] so that [F5] indicates “A.Mix,” and then
press [F5 (A.Mix)].
fig.4-02
4. Press [F2 (Micro)].
5. Press [PAGE] so that [F1] indicates “In.”
fig.4-03
6. Make sure that the cursor is located at “Edit Target,” and
use the TIME/VALUE dial to select the type of automix
data that you wish to edit.
7. Use [
][
] to move the cursor to the first marker of
the area from which you wish to copy automix data, and
press [F1 (In)].
8. Use [
][
] to move the cursor to the last marker of
the area from which you wish to copy automix data, and
press [F1 (Out)]. A check mark will be added to the copy
area.
fig.4-04.e
0 M0
M1
M2
M3
M4
M5
Time
0 M0
M1
M2
M3
M4
M5
Time
Copy area
Destination
Marker
Check marks