Roland VS-1680 用户手册
23
Editing an automix
fig.4-18.e
11. To execute the Gradation operation, press [F4 (Exec)]. If
you press [F6 (EXIT)], you will return to step 7 without
executing the Gradation operation.
12. A message will ask you to confirm the operation. Press
[YES]. If you press [NO], the Gradation operation will be
halted, and you will return to step 11.
fig.4-19
13. When the Gradation operation has been executed, the
display will indicate “Complete.” Press
[PLAY (DISPLAY)].
Increasing or decreasing all
data values (Shift/Expand)
data values (Shift/Expand)
This operation increases or decreases the values of the
automix data in a specific area. This can be done in two ways:
Shift
adds (or subtracts) the same amount to each auto-mix
data value, and
Expand
increases or decreases all auto-mix
data values by the same proportion relative to a specified
standard value.
fig.4-20.e
NOTE
Editing of the automix data cannot be cancelled by the Undo
function (VS-1680 Owner’s Manual, p. 160).
1. Press [PLAY (DISPLAY)].
2. Hold down [SHIFT] and press [F6 (UTIL)].
3. Press [PAGE] so that [F5] indicates “A.Mix,” and then
press [F5 (A.Mix)].
fig.4-02
4. Press [F2 (Micro)].
5. Press [PAGE] so that [F1] indicates “In.”
fig.4-03
6. Make sure that the cursor is located at “Edit Target,” and
use the TIME/VALUE dial to select the automix data
that will be increased or decreased.
7. Use [
][
] to move the cursor to the first marker of
the automix data that you wish to increase or decrease,
and press [F1 (In)].
8. Use [
][
] to move the cursor to the last marker of
the automix value that you wish to increase or decrease,
and press [F1 (Out)]. Check marks will be added to the
selected area.
0 M1
M5
Time
Gradation area
0 M1
M8
Time
Gradation area
0
M1
M8
Time
0
M1
M8
Time
0
M1
M8
Time
0
M1
M8
Time
Shift
Expand