Roland VS-1680 用户手册
9
Mix 16 tracks down to 2 tracks (Mastering Room)
Status
Specify the status of the mastering tracks. For this example,
select “Off.”
Off
:
The mastering tracks will not be used.
Rec
:
Play back tracks 1–16 while recording them to the
mastering tracks.
Play
: Play back the mastering tracks. The sound of tracks
1–16 will not be output from the MASTER jacks.
MEMO
For details on the signal flow (routing) at this time, refer to
Signal flow (routing)
(p. 10).
Trk L (track L)
Trk R (track R)
Select the two V-tracks (L and R) that will be assigned as
mastering tracks. When a new song is created, V-track 16 of
tracks 15/16 (15-16, 16-16) will be assigned as the mastering
tracks.
After Rec (after recording)
Specify the time location of the mastering track to which the
mixdown will be recorded. When creating an original audio
CD, it is usually best to select “to ZERO.”
to ZERO
:
Place the data starting at 00h00m00s00f
to last Phrs:0S
: Place the data after the end of the last
phrase in the mastering tracks.
to last Phrs:2S
: Place the data two seconds after the end of
the last phrase in the mastering tracks.
to last Phrs:4S
: Place the data four seconds after the end of
the last phrase in the mastering tracks.
Stay HERE
:
Place the data at the time location at which
it was actually recorded.
fig.2-05.e
Marker
If this is turned “On,” a track number marker will
automatically be assigned to the beginning of the phrase that
is mixed down. Normally you will set this “On.”
MEMO
Depending on the After Rec (After Recording) setting or on
the location relative to other markers, the display may
indicate “Can’t Set Marker,” and the track number marker
may not be assigned.
5. Hold down [STOP], and press the [STATUS] button for
all tracks (1–15/16) that you wish to mixdown. The
STATUS indicators will light green.
fig.2-06
6. Press [FADER] so that the TR (track) indicator lights.
fig.2-07.e
7. Press [PLAY]. The song will play back.
8. Raise and lower the master fader, and verify that the
volume of each track changes.
MEMO
The sound that passes through the master fader will be
recorded on the mastering tracks.
In order to record at the
optimal audio quality, you should normally set this to the
0 dB position.
9. Use the channel faders (1–15/16) to adjust the volume
balance of each track. At this time the sound that is being
output from the MASTER jacks (volume levels, panning)
will be recorded to the mastering tracks. It is best to set
the volume as high as possible without causing the
volume to distort.
10. When you have finished adjusting the volume, press
[STOP].
11. Move to the location at which you wish to begin the
mixdown (such as 00h00m00s00f).
0
Time
Mixdown
Phrase
Original
Phrase
0
Time
0
Time
0
Time
0
Time
0
Time
to ZERO
to LastPhrs:0s
to LastPhrs:2s
to LastPhrs:0s
Stay HERE
Lit
Dark