Zebra 77660 用户手册
13358L Rev. 1 11/17/03
Z4Mplus and Z6Mplus Maintenance Manual
83
Preventive and Corrective Maintenance
Section 4
Replace Main Logic Board
Caution:
Caution • This installation must be performed by a qualified service technician.
Caution • This installation must be performed by a qualified service technician.
Caution • Turn Off (O) the printer and disconnect the printer from the power
source before performing the following maintenance.
source before performing the following maintenance.
Remove Main Logic Board
1.
Print a configuration label by pressing and holding CANCEL while turning On (
l
)
the printer. Set the label aside for future use.
2.
Turn Off (
O
) the printer and remove the AC power cord and data cables.
3.
Refer to Figure 4-21. Open the media door, remove the electronics cover mounting
screw and lock washer.
screw and lock washer.
4.
Remove the media and ribbon.
5.
Close the media door.
Figure 4-21. Locate Electronics Cover Mounting Screw
Note •
If the printer is operating it is advisable to print a configuration label.
Electronics
Cover
Media
Door
Electronics
Cover
Mounting
Screw
Cover
Mounting
Screw
Lock Washer
Lower
Flange
Flange
Upper
Flange
Flange