Zebra 77660 用户手册
88
Z4Mplus and Z6Mplus Maintenance Manual
13358L Rev. 1 11/17/03
Section 4
Preventive and Corrective Maintenance
4.
Reinstall, but do not tighten, the screw and washer securing the serial port
connector.
connector.
5.
Reinstall, but do not tighten, the two screws and washers securing the parallel port
connector.
connector.
6.
Reinstall the two mounting screws securing the main logic board to the mounting
bracket.
bracket.
7.
Tighten the two screws securing the parallel port first then tighten the other screws.
8.
Refer to Figure 4-26. Reinstall all connectors on the main logic board, ensuring they
are in their proper locations.
are in their proper locations.
9.
Refer to Figure 4-24. Reinstall the PCMCIA socket board.
10.
Refer to Figure 4-23. Reinstall the PSII board and cable assembly.
11.
Refer to Figure 4-22. Reinstall the electronics cover by aligning the bottom flange
inside the base and the top flange between the main frame and media door.
inside the base and the top flange between the main frame and media door.
12.
Refer to Figure 4-21. Reopen the media door and reinstall the mounting screw and
lock washer to secure the electronics cover.
lock washer to secure the electronics cover.
13.
Reinstall the media and ribbon.
14.
Reinstall the AC power cord and data cables.
15.
Turn On (
l
) the printer. Allow the printer to go through the power-on selftest
(POST).
16.
Press SETUP/EXIT two times.
17.
Press
or
until LOAD DEFAULTS is displayed, then press
SETUP/EXIT. This resets all settings to the factory default.
18.
Turn Off (
O
) the printer.
19.
Press and hold CANCEL while turning On (
l
) the printer. A configuration label
prints.
20.
Compare the configuration label with the label you printed previously.
21.
Reconfigure the printer using the User Guide.
Note •
Ensure the PSII Cable is firmly connected to the PSII I/O board.
Note •
If the printer does not go through the POST, turn the printer off, disconnect the
AC power cord and remove the electronics cover. Verify that all connections are in the
proper position and fully seated in their connectors. Reinstall the electronics cover,
reconnect the AC power cord and Turn On (
proper position and fully seated in their connectors. Reinstall the electronics cover,
reconnect the AC power cord and Turn On (
l
) the printer. When the printer displays
READY, continue to step 16.