Zebra 77660 用户手册
13358L Rev. 1 11/17/03
Z4Mplus and Z6Mplus Maintenance Manual
93
Preventive and Corrective Maintenance
Section 4
Install the Power Supply Board
1.
Refer to Figure 4-31. Place the insulator pad over the locating pins on the printer.
Verify that all holes align with holes in the main frame.
Verify that all holes align with holes in the main frame.
Figure 4-31. Install the Insulator and Insulating Pad
2.
Place the insulator onto the locator pins. Verify that all holes align with holes in the
main frame
main frame
3.
Carefully slide the power supply board’s AC power switch into the opening
provided, then place the power supply board onto the insulator, insulator pad, and
locating pins.
provided, then place the power supply board onto the insulator, insulator pad, and
locating pins.
I
Caution • Improper alignment or installation of this insulator pad can cause
injury.
injury.
Mounting
Screws
Power
Supply
Nut
Bar
Bar
Insulator
Pad
Locating
Pins
Mounting
Screws
Insulator
Standoff
Note •
On new power supplies shipped from the factory, carefully break away any
excess scored pieces of PCB material left to protect the components during shipping.
Caution must be used to prevent damage to components.
Caution must be used to prevent damage to components.