Zebra 77660 用户手册
104
Z4Mplus and Z6Mplus Maintenance Manual
13358L Rev. 1 11/17/03
Section 4
Preventive and Corrective Maintenance
6.
Reinstall the screw through the washer and ground strap. Tighten the screw to snug
in the new front panel.
in the new front panel.
7.
Refer to Figure 4-39. Reinstall the electronics cover by aligning the bottom flange
inside the base and the top flange between the main frame and media door.
inside the base and the top flange between the main frame and media door.
8.
Refer to Figure 4-38. Open the media door and reinstall the mounting screw and
lock washer
lock washer
9.
Reinstall the media and ribbon, and close the media door.
10.
Reinstall the AC power cord and data cables.
11.
Turn On (
l
) the printer.
12.
Set up the front panel according to the previously printed configuration label. Print a
configuration label using the Cancel Key Self Test. Compare results and adjust as
necessary.
configuration label using the Cancel Key Self Test. Compare results and adjust as
necessary.
13.
If a configuration label could not be printed before removing the old front panel,
perform the label quality procedure in your User Guide.
perform the label quality procedure in your User Guide.
Note •
Use caution when securing the front panel that the ground cable does not rotate
more than 1/8 turn.