Zebra 77660 用户手册
13358L Rev. 1 11/17/03
Z4Mplus and Z6Mplus Maintenance Manual
117
Preventive and Corrective Maintenance
Section 4
Replace Reflective Media Sensor
Caution:
Caution • This installation must be performed by a qualified service technician.
Caution • This installation must be performed by a qualified service technician.
Caution • Turn Off (O) the printer and disconnect the printer from the power
source before performing the following maintenance.
source before performing the following maintenance.
Remove Reflective Media Sensor Assembly
1.
Turn Off (
O
) the printer and remove the AC power cord and data cables.
2.
Refer to Figure 4-53. Open the media door, remove the electronics cover mounting
screw and lock washer.
screw and lock washer.
3.
Remove the media and ribbon.
4.
Close the media door.
Figure 4-53. Locate Electronics Cover Mounting Screw
5.
Refer to Figure 4-54. Press in on the electronics cover with palm of hand, then lift
up on the cover to remove it.
up on the cover to remove it.
Electronics
Cover
Media
Door
Electronics
Cover
Mounting
Screw
Cover
Mounting
Screw
Lock Washer
Lower
Flange
Flange
Upper
Flange
Flange