Zebra 77660 用户手册
13358L Rev. 1 11/17/03
Z4Mplus and Z6Mplus Maintenance Manual
121
Preventive and Corrective Maintenance
Section 4
6.
Thread and wrap the sensor wires through and around the ferrite the same as the
wires you removed. See detail in Figure 4-55.
wires you removed. See detail in Figure 4-55.
7.
Connect the media sensor connector to the main logic board at P7.
8.
Refer to Figure 4-54. Reinstall the electronics cover by aligning it and sliding down,
ensuring the lower flange is inside the base and the upper flange is between the main
frame and the media door.
ensuring the lower flange is inside the base and the upper flange is between the main
frame and the media door.
9.
Refer to Figure 4-53. Reopen the media door and reinstall the mounting screw and
lock washer to secure the electronics cover.
lock washer to secure the electronics cover.
10.
Reinstall the media and ribbon.
11.
Reconnect the AC Power cord and data cables.
12.
Turn On (
l
) the printer.