Zebra 77660 用户手册
172
Z4Mplus and Z6Mplus Maintenance Manual
13358L Rev. 1 11/17/03
Section 4
Preventive and Corrective Maintenance
11.
Carefully slide the rewind motor and spindle assembly out of the rewind pan while
guiding the media rewind cable through the hole in the bottom of the main frame.
guiding the media rewind cable through the hole in the bottom of the main frame.
12.
Refer to Figure 4-111. Remove the E-ring from the rewind shaft.
13.
Remove the flat washers and wave washer from the shaft.
14.
Remove the rewind spindle from the rewind shaft.
Figure 4-111. E-Ring Removal and Installation
Caution • Observe proper electrostatic safety precautions when handling any
static-sensitive components such as circuit boards and printheads.
static-sensitive components such as circuit boards and printheads.
15.
Refer to Figure 4-112. Remove and retain the two mounting screws that secure the
rewind PCB assembly to the rewind support.
rewind PCB assembly to the rewind support.
16.
Cut the cable tie securing the media rewind cable to the PCB assembly.
17.
Disconnect the media rewind cable from the connector on the PCB.
Caution • Wear protective eyewear when removing E-rings, C-clips, snaprings,
and springs. These are under tension and could fly off while removing.
and springs. These are under tension and could fly off while removing.
Rewind
Motor/Spindle
Assembly
E-Ring