Zebra 77660 用户手册
178
Z4Mplus and Z6Mplus Maintenance Manual
13358L Rev. 1 11/17/03
Section 4
Preventive and Corrective Maintenance
Figure 4-116. Steer Knob Removal and Installation
10.
Remove and discard flat washer, wave washer and spacers.
Install Steer Knob and Steering Roller
1.
Refer to Figure 4-116. Install the spacers onto the studs on the inside of the outside
plate.
plate.
2.
Install the steer knob in the outside mounting plate.
3.
While holding the steer knob, slide the wave washer and flat washer onto the knob
and install the snap ring.
and install the snap ring.
4.
Refer to Figure 4-115. Install the steering roller assembly by inserting the knob side
first. Align the two vertical oblong holes with the two spacers and turn the knob
such that it inserts into the horizontal hole. Swing the large tab side into position, a
slight pressure to the outside and the inside mounting plates will be needed.
first. Align the two vertical oblong holes with the two spacers and turn the knob
such that it inserts into the horizontal hole. Swing the large tab side into position, a
slight pressure to the outside and the inside mounting plates will be needed.
5.
Install the thumb screw.
6.
Reinstall the ribbon and media.
7.
Close the rewind pan door.
8.
Close the Media door.
9.
Reconnect the AC power cord and data cables.
10.
Turn On (
l
) the printer.
Slot
Steer
Knob
Knob
Spacer
Wave Washer
Flat Washer
Snap Ring
Steering Roller
Assembly
Thumb Screw
Large Tab
Note •
Care must be taken not to bend the mounting plates.