Zebra 77660 用户手册
13358L Rev. 1 11/17/03
Z4Mplus and Z6Mplus Maintenance Manual
9
System Description
Section 1
Communication Specifications
Serial Data Communication Interface Overview
A single data terminal equipment (DTE) port supports RS-232, RS-422 and RS-485 serial
data communications. Baud rate, parity, data length, stop bits, and XON/XOFF or DTR
control protocols are front panel selectable.
data communications. Baud rate, parity, data length, stop bits, and XON/XOFF or DTR
control protocols are front panel selectable.
Refer to Figure 1-2. A 9-pin DB9S connector at the rear of the printer provides the data
and control leads necessary to communicate through all three signaling protocols. The
method used is specific to the application of the printer.
and control leads necessary to communicate through all three signaling protocols. The
method used is specific to the application of the printer.
For all RS-232 data and control input and output signals, Zebra follows both the
Electronic Industries Association’s (EIA) RS-232 and the Consultative Committee for
International Telegraph and Telephone (CCITT) V.24 specifications.
Electronic Industries Association’s (EIA) RS-232 and the Consultative Committee for
International Telegraph and Telephone (CCITT) V.24 specifications.
Figure 1-2. Interface Connections Z4Mplus and Z6Mplus
DB25S
Connector
Connector
DB9S
Connector
Connector
AC Power
Switch
Switch
AC
Connector
Connector