Zebra 77660 用户手册
30
Z4Mplus and Z6Mplus Maintenance Manual
13358L Rev. 1 11/17/03
Section 2
Operations Overview
Peel Rewind (Peel-Off Mode)
Refer to Figure 2-9.
1.
Press the printhead open lever. The printhead assembly springs up.
2.
Flip down the media supply guide.
3.
Slide the media guide out as far from the printer frame as possible.
4.
Place the roll of media on the media supply hanger.
5.
Flip up the media supply guide. Slide the media supply guide in until it just touches,
but does not restrict, the edge of the roll.
but does not restrict, the edge of the roll.
6.
Feed the media under the dancer, through the slot in the transmissive sensor, and
under the ribbon sensor.
under the ribbon sensor.
7.
Pull approximately 36 in. (1 m) of media through the front of the printer
8.
Remove the labels from about 18 in. (500 mm) of media so only the liner remains.
9.
Ensure the media is against the back of the transmissive sensor. Slide in the media
guide until it just touches, but does not restrict, the edge of the media.
guide until it just touches, but does not restrict, the edge of the media.
10.
Pull the lever to open the pivot bracket assembly.
11.
Feed the media over the tear-off/peel-off bar and behind the pivot bracket assembly.
12.
Close the printhead assembly.
13.
Close the pivot bracket assembly.
14.
Loosen the thumbscrew and slide out the rewind media guide to the end of the
take-up spindle.
take-up spindle.
15.
Wrap the liner around a core placed on the take-up spindle. Turn the take-up spindle
counterclockwise to wind up the excess liner.
counterclockwise to wind up the excess liner.
16.
Slide the rewind media guide against the liner and tighten the thumbscrew to lock it
into position.
into position.
17.
Peeling will automatically start. Press FEED to test.