ZyXEL 4-port Prestige 792H Router 91-004-342001 用户手册
产品代码
91-004-342001
Prestige 791R G.SHDSL Router
Remote Node TCP/IP Configuration
24-5
Table 24-1 Remote Node Profile
FIELD DESCRIPTION
EXAMPLE
Schedule Sets This field is only applicable for PPPoE and PPPoA
encapsulation. You can apply up to four schedule sets
here. For more details please refer to the Call Schedule
Setup chapter.
here. For more details please refer to the Call Schedule
Setup chapter.
Nailed up Connection This field is only applicable for PPPoE and PPPoA
encapsulation. This field specifies if you want to make
the connection to this remote node a nailed-up
connection. More details are given earlier in this
section.
the connection to this remote node a nailed-up
connection. More details are given earlier in this
section.
Session Options
Edit Filter Sets
Use [SPACE BAR] to choose Yes and press [ENTER]
to open menu 11.5 to edit the filter sets. See the
Remote Node Filter section for more details.
to open menu 11.5 to edit the filter sets. See the
Remote Node Filter section for more details.
No
(default)
Idle Timeout (sec) Type the number of seconds (0-9999) that can elapse
when the Prestige is idle (there is no traffic going to the
remote node), before the Prestige automatically
disconnects the remote node. 0 means that the session
will not timeout.
remote node), before the Prestige automatically
disconnects the remote node. 0 means that the session
will not timeout.
When you have completed this menu, press [ENTER] at the prompt “Press ENTER to confirm or ESC to
cancel” to save your configuration or press [ESC] to cancel and go back to the previous screen.
cancel” to save your configuration or press [ESC] to cancel and go back to the previous screen.
24.3 Remote Node Network Layer Options
Perform the following steps to edit Menu 11.3 – Remote Node Network Layer Options as shown next.
Step 1. In menu 11.1, make sure IP is among the protocols in the Route field.
Step 2. Move the cursor to the Edit IP/Bridge field, press [SPACE BAR] to select Yes, then press
[ENTER] to display Menu 11.3 – Remote Node Network Layer Options.
Menu 11.3 - Remote Node Network Layer Options
IP Options: Bridge Options:
IP Address Assignment= Dynamic Ethernet Addr Timeout (min)= N/A
Rem IP Addr: 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= 0.0.0.0
My WAN Addr= 0.0.0.0
NAT= Full Feature
Address Mapping Set= 2
Metric= 2
Private= No
RIP Direction= None
Version= RIP-1
Version= RIP-1
Multicast= None
IP Policies= 3,4,5,6
Press ENTER to Confirm or ESC to Cancel: