ZyXEL Prestige 202H Plus ISDN Router 91-003-154001B 用户手册

P-202H Plus v2 User’s Guide

Chapter 26 SNMP Configuration

252

The following table describes the SNMP configuration parameters.

The ZyXEL Device will send traps to the SNMP manager when any one of the following 
events occurs:

The port number is its interface index under the interface group.

Table 82   Menu 22 SNMP Configuration

SNMP:

Get Community

Type the Get Community, which is the password for the incoming Get- and 

GetNext requests from the management station.

Set Community

Type the Set Community, which is the password for incoming Set requests from 

the management station. 

Trusted Host

If you enter a trusted host, your ZyXEL Device will only respond to SNMP 

messages from this address. A blank (default) field means your ZyXEL Device will 

respond to all SNMP messages it receives, regardless of source.

Trap:

Community

Type the trap community, which is the password sent with each trap to the SNMP 

manager. 

Destination

Type the IP address of the station to send your SNMP traps to.

When you have completed this menu, press [ENTER] at the prompt “Press ENTER to confirm or ESC 

to cancel” to save your configuration or press [ESC] to cancel and go back to the previous screen.

Table 83   SNMP Traps

1

coldStart (defined in RFC-1215)

A trap is sent after booting (power on).

2

warmStart (defined in RFC-1215)

A trap is sent after booting (software reboot).

3

linkUp (defined in RFC-1215)

A trap is sent with the port number.

4

authenticationFailure (defined in 

A trap is sent to the manager when receiving any 

SNMP get or set requirements with wrong 

community (password).

6

linkDown (defined in RFC-1215)

A trap is sent with the port number when any of the 

links are down. See the following table.

Table 84   Ports and Permanent Virtual Circuits

1

Ethernet LAN

2

1

3

2